User manual JANE STRATA

[. . . ] You can also use your STRATA with any JANÉ chassis that has the PROFIX system. You must follow these instructions to ensure that your baby is adequately protected, comfortable and securely fastened inside the car: Your STRATA safety seat can be installed on both the front seat, if it is not fitted with an Air-Bag, and the back seat of the car. [. . . ] Avoid difficulties in installing and uninstalling straps when you need to change the height of the seat belts. Choosing where to install the safety seat Choosing the right place where you want to install the safety seat in the car will reduce the risk of injury to your baby in the event of an accident. We strongly recommend that the baby is accompanied by someone sitting next to them to take care of their every need. If you are travelling alone with your baby, it is good if you can see them without having to take your eyes off the road. Put them in the passenger seat providing that it is NOT fitted with an Air-Bag or IT IS DISCONNECTED. Under no circumstances allow yourself to be distracted from the road to see to your baby. Adjusting the height of the shoulder straps To ensure that they offer maximum protection, the shoulder straps on the STRATA safety seat must be set just above the baby's shoulders. The lowest positions of the headrest, which are for the first few months of use, are connected to an automatic system that raises the base of the seat. Changing the position of the handle The handle has 4 positions (2c), each of which has a specific function: Position 1: Stability, the handle stops it from tipping over when on a flat surface. To change position, press the lever on the handle (2d) and turn the handle until you reach the desired position. The STRATA safety seat has a quick system for controlling the height of the shoulder straps. 2b Release the switch and move the headrest until it reaches the nearest locking position, when you should hear a click. The STRATA safety seat must be installed FACING THE OPPOSITE DIRECTION IN WHICH THE CAR IS TRAVELLING. Decide on the seat after reading the "Choosing where to install the safety seat" section. [. . . ] Remove the cover from the tightener button area and finally undo the Velcro on the central part and remove the cover upwards. Make sure that inside the car, luggage and any other object likely to cause harm in an accident are correctly fastened or stored. [. . . ]