User manual JANE RIDER REVERSE

[. . . ] The maximum amount carried in the basket must never exceed the weight indicated on the basket (4 kg). - FITTING AND REMOVING THE WHEELS Before using the RIDER pushchair for the first time it is necessary to fit the rear wheels. To fit the wheels press the button on the middle of the wheel and insert the axle into the rear wheel bearer and push until it slots firmly into place. 1 If you need to remove the wheels, press the central button and take the wheel off. [. . . ] During these operations the appearance of sharp points and compression areas are inevitable. - ADJUSTING THE ANGLE OF THE HAMMOCK The hammock can be reclined so your baby can travel in the most comfortable position possible at all times. Pull the lever on the upper part of the hammock and tilt it to one of the 3 possible positions. 10 WARNING: Position P is only to be used when folding the pushchair, you must not use this position when your baby is in the hammock. - USING THE SAFETY ARMREST The safety armrest is designed to fit into the slots on the hammock. If required it is possible to release one side of the armrest and it will still be completely articulated by the other side. 12 -12a WARNING: The child should be kept away from the mobile parts when the responsible adult is handling these. The appearance of cutting, compression and pinch points are inevitable during these operations. - USING THE HOOD To fasten the hood onto the frame of the hammock, slide it from the top down to the corresponding slots on the central part. - SEAT BELT Your pushchair has a safety harness to keep your child safe at all times. - ADJUSTING THE FOOTREST The footrest can be adjusted to 5 different positions. Use your thumb to simultaneously press the two buttons on the lower part of the hammock. 16 english 27 The handlebar can be set to 7 different positions. A To adjust the brake: If you need a more precise adjustment follow the indications in figure. 18 WARNING: When the brake is on make sure that the pushchair has braked correctly. It may be necessary to push the pushchair slightly for the brake to be fully activated. - ADJUSTING THE STRENGTH OF THE SUSPENSION To increase the strength turn the lever clockwise. - LOCKING THE FRONT WHEELS To lock the front wheels, press the button situated behind each front wheel bearer. [. . . ] The label displaying the chassis number of the model should never be taken off, it contains important information. Notice: For the maximum safety and care of your new JANÉ product, it is very important that you complete the registration card found on the web page www. Es This registration means we can inform you, if necessary, of the evolution and maintenance of your product. Additionally, if you would like, we can also inform you about new models or news that we think may be useful for you. [. . . ]