User manual JANE MATRIX LIGHT 2

[. . . ] Not all safety systems are exactly the same, so we advise that you check your MATRIX LIGHT in the car in which it is going to be fitted. It is very important not to use second-hand products, as JANÉ can only guarantee complete safety with items used by their first buyer. JANÉ recommends that you replace your MATRIX LIGHT safety seat with a new one if it has been subjected to violent stresses in an accident. Check that all the straps are in the correct position and duly adjusted to your MATRIX LIGHT. [. . . ] It has the following features: Installing in the vehicle: Belt slots underneath the shell to permit installation in cars where the belts are shorter. Car seat belt lock that tightens the seat for more stability in the sitting position. Comfort and safety for the baby: Integrated 5-point straps, with a greater fastening area, so distributing loads on the baby better in the event of an accident. Impact-absorbent material over the entire surface in contact with the baby. 4-position reclining backrest: R1 - Group 0 position, so that the baby can travel fully reclining. 1 Adju MATRIX LIGHT For safe Chec in th The your The justm justm 1a 22 Comfort for the parents: Pro-Fix fasteners compatible with the JANE chasses. Avoids the inconvenience of having to fasten and unfasten straps when you need to change the height of the straps. Rele the n locke 1 Prior adjustments Changing the position of the handle The carrying handle has 3 positions ( figure 1b ), each one of them has a specific function: Position 1: Hood folded. Position for installing the seat and taking it off a JANÉ chassis and for carrying. To change the position, press the double safety catch and then the lever on the handle and turn the handle to the required position. Adjusting the height of the shoulder straps For maximum protection the shoulder straps of the MATRIX LIGHT safety seat should be adjusted to just above the baby’s shoulders. 2e - To take the TRANSPORTER seat out of the vehicle, open the fastener of the belt by turning the lock and take the seat belt off. If you observe that the car seat belts are not long enough, you can adjust the following parameters to improve this: - Recline the backrest of the car seat a little. - Adjust the shoulder height regulator of the car seat belts to - Move the car seat back. English 25 3 Placing the baby in the safety seat WARNING Never leave the baby on their own. Always remember to carry your baby with the safety harnesses correctly buckled. For your baby’s proper development, we advise you not to over-use the carry cot in the seated position on long journeys, letting the baby rest in the reclining position (for babies up to 10 Kg). Any alteration or addition to the device without proper authorisation from JANÉ may seriously alter the safety of the retaining system. Failure to follow the instructions carefully for the correct use of the retaining system may be dangerous for the safety of the baby. This safety device cannot be used without its cover, or be replaced by another cover that is not the original, as this is an integral part of the safety features of the system. Ensure that the belt has not been caught between the folding seats or doors. It is only suitable for cars fitted with three anchoring point automatic belts, approved according to Regulation ECE-16 or other equivalent rules. [. . . ] MATRIX LIGHT 4 Using your MATRIX LIGHT in a pushchair MATRIX LIGHT can be anchored on any JANÉ chassis that has the PROFIX system. 4a - To fit the safety seat on a chassis, insert the connections in the cavity of the chassis and press until you hear a click. 4b - To release your MATRIX LIGHT from the chassis, press the button on the handle and pull the seat upwards. Not all safety systems are exactly the same, so we advise that you check your MATRIX LIGHT in the car in which it is going to be fitted. [. . . ]