User manual JANE MATRIX LIGHT

[. . . ] In order to protect your baby adequately and to ensure their comfort and stability in the car, the following instructions must be strictly followed: Your MATRIX LIGHT safety seat can be installed in both the front seat, if it does not have an airbag, and in the back seat of your car. If you position it in the front seat of the car, this must NOT have an AIRBAG, or the airbag must be disconnected. It is only suitable for cars fitted with three anchoring point automatic belts, approved according to Regulation ECE-16 or other equivalent rules. [. . . ] 2 To change the position when sitting down, press the button on the backrest and slide it to the required position. Aps Release the button or flap and move the adjustment mechanism to the nearest locking position, it should click into place. Choosing where to install the safety seat Correctly choosing where to position the safety seat in the car can reduce the risk of injury to the baby in the event of an accident. MATRIX LIGHT occupies two seats: you can choose between a side and a middle seat, so an adult can travel alongside, or completely in the middle. If you decide on middle and side seats, place the MATRIX LIGHT so that the head is as far as possible from the door. It is highly advisable that someone travels alongside the baby to take care of them. If you are travelling alone with your baby, it is a good idea to keep them in sight without being distracted while driving. You can position them in the passenger seat, providing it does NOT have an airbag or the airbag IS DISCONNECTED. Do not be distracted for any reason while driving: to take care of the baby, stop the car completely in a safe place. The MATRIX LIGHT safety seat must be installed FACING AWAY FROM THE DIRECTION OF TRAVELLING. Decide on which seat after reading the section on "Choosing where to install the safety seat". 2h - Pass the abdominal part of the car seat belt through the two front guides situated on the sides of the frame. 2i - The shoulder belt of the car should be passed behind the safety seat. In the reclining position, MATRIX LIGHT must be fitted cross-wise on the back seats. Decide on which seats after reading the section on "Choosing where to install the safety seat". 2a - Fasten the two straps you have chosen, the fasteners are on the abdominal part of the belt, this area is marked in light blue in the diagrams. [. . . ] Wash the plastic parts with warm water and soap, carefully drying all the components afterwards. Unfasten the safety harness clip and pass it through the slot in the upholstery. Take off the rubber bands that go underneath the car seat belt fasteners. [. . . ]