User manual JAMO MANNO13%2C+JSS4-TS

[. . . ] JSS4-TS WARNING: Improper installation could result in damage to the amplifier. Read all instructions before installation. Your JSS4-TS speaker selector allows simultaneous operation of up to 4 pairs of 8 Ohm speakers. [. . . ] Allow room for adequate ventilation around the switch box, it can become quite warm if operation at high power with the productive resistors switched in. The JSS4 front panel buttons all operate in the same manner, push to turn ON, push again to turn OFF. The switch is ON when pushed in closest to the JSS4 front panel. Installation Caution: Do not apply audio power in excess of 155 watts per channel when the internal impedance matching resistors are switched in!DAMAGE TO COMPONENTS CAUSED BY EXCESSIVE POWER APPLICATION IS NOT COVERED UNDER WARRANTY. To make a connection, strip about ¼in of insulation from the end, twist any loose strands together tightly so that no loose end sticks out to cause problems with short circuits. Make the connection by unscrewing the binding post counterclockwise and exposing the wire hole. Insert the stripped wire end into the wire hole and tighten the binding post by turning it clockwise. Make sure the metal conductor contacts the stripped part of the wire, not the insulation, and there are no loose strands to cause problem short circuits. Observe polarity when making connections, making sure +(plus) goes to + (plus), - (minus) goes to (minus) and that the channels are not crossed. Improper connections can cause the system to be inoperative or less than optimum. Following the same precautions, connect the speaker wires to the appropriate JSS4 terminals marked output. Connection The warranty period will come into force as from the purchase date stated on the invoice. [. . . ] The supplier is liable only to repair or replace defective parts or products. A replacement cannot exceed the value of the product under warranty. 69441 / 33. 2000 [. . . ]