User manual JABRA GN8000

[. . . ] All GN Netcom A/S products are designed and manufactured in accordance with strict quality standards and should, with a minimum of maintenance, give many years of satisfactory use. The information in this user guide is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by GN Netcom A/S. [. . . ] Note: A beeping noise in the headset indicates that the batteries are low. On-line Indicator 17 The on-line indicator flashes red when the telephone is off-hook, indicating that you are on the phone. Rotate the on-line indicator so the light is seen from the best direction for your work area. Tips 18 The quick disconnect (QD) allows you freedom of movement without removing the headset. If you disconnect your headset at the QD during a conversation, you automatically place your caller on hold. Lift the amplifier top cover and adjust the microphone volume towards the left to a lower number. â· A beeping noise in your headset may indicate that the batteries in your amplifier are low. â· Make sure the headset stand/on-line indicator is plugged all the way into the port on the rear of the amplifier. Connect the plug with the speaker icon into the jack of the computer or sound board marked with a speaker or a headset icon. Connect the plug with the microphone icon to the jack of the computer marked with the microphone icon. Telephone/PC switch 21 To use the headset for telephone or PC, set the switch in either telephone or PC position. Microphone mute switch The mute switch for the microphone is functional in both telephone mode and computer mode: 22 When the amplifier is in telephone mode and mute function is activated, the microphone is muted to the telephone and turned on to the computer. If you have any problems or questions regarding GN 8000, please contact your reseller. Hereby, GN Netcom as declares that this GN 8000 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC (www. [. . . ] â· You may have the system selector switch in a position that does not correspond with your telephone. Lift the amplifier top cover and move the systems selector switch to another position. [. . . ]