User manual JABRA BT 250V

[. . . ] You are now ready to "pair" Jabra BT250v to your mobile phone. If the headset has already been paired to your phone, then you can begin using it. WARNING: Do not attempt to charge Jabra BT250v with anything other than the AC adaptor provided. IMPORTANT: The blue indicator light will be on while charging and will turn off when charging is complete. [. . . ] Set your Bluetooth phone to "discover" the headset by following your phone's instruction guide. Typically, the steps involve going to a "setup, ""connect, " or "Bluetooth" menu on your phone and then selecting the option to "discover" a Bluetooth device*. Your phone will find the "Jabra BT250v" headset and ask if you want to pair with it. Enter passkey or PIN = 0000 (4 zeros), then press "yes" or "ok. If the headset is not responding or the blue light will not turn on or off after pairing, you may need to RESET your headset. Leave the headset in the charging cradle for about 3 seconds, then remove the headset (see Fig. (Such as Nokia 6310 and 8910 series) Please ensure that the headset is allowed by the phone to connect without authorization. * Phone-specific pairing instructions and the most current list of phones with hands-free profile can be found online at www. IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly before going back to flashing every 3 seconds. If unsuccessful, the light remains solid, and you'll need to reattempt pairing (see steps 3­5 above). Once you're done pairing, the following new headset features will be available: Last number redial (when not on a call) While the headset is on, press and hold until you hear 2 short beeps, release immediately Rejecting an incoming call (when not on a call) When your phone rings, press and hold until you hear 2 short beeps, release immediately Call-waiting (swapping between 2 calls) When your phone notifies you of another incoming call while you're on a call, press and hold until you hear 2 short beeps, release immediately Putting a call on hold While you're on a call, press and hold until you hear 2 short beeps, release immediately. Repeat to retrieve the call Can other Bluetooth phone users hear my conversation?When you pair your headset to your Bluetooth phone, you are creating a private link between only these two Bluetooth devices. The wireless Bluetooth technology used in your headset is not easily monitored by third parties because Bluetooth wireless signals are significantly lower in radio frequency power than those produced by a typical mobile phone. The headset itself is primarily made of thermoplastic polyurethane, which is a soft plastic. The face of the headset, where the buttons are located, is made of polycarbonate, a very strong, hard plastic. To clean the headset, use a clean, soft cloth that is slightly damp To clean the MiniGel, remove it from the headset by gently lifting and pulling it off the speaker housing. Then, wash it in warm, soapy water How far away from my phone will my Jabra BT250v work?Jabra BT250v will work with devices that are compliant with Bluetooth version 1. 1 or higher specifications and support the headset and/or hands-free profile(s). Will anything cause interference with my conversation when I'm using my Jabra BT250v?Appliances such as cordless phones and wireless networking equipment may cause interference with your conversation, usually adding a crackling noise. [. . . ] 4 Passkey or PIN is a secret code that needs to be entered on the phone in order to pair the mobile phone with Jabra BT250v. When you have already paired your mobile phone with Jabra BT250v, the phone and headset will recognize each other and the phone will bypass the discovery and authentication process and automatically accept the transmission. Jabra BT250v will go from standby mode into active mode when you receive a call or when you make a call. When Jabra BT250v is in active mode, the blue light will flash every second. [. . . ]