User manual ITI ADVENT HOME NAVIGATOR SYSTEM REV B

[. . . ] 60-562-02, 60-562-05 $GYHQW +RPH 1DYLJDWRU 6\VWHP Document Number: 466-1318-ITI Rev. B February 2001 Contents Welcome . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 System Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Alarm ALARM CANCELED If canceled soon enough - within 5 seconds (programmable) - the alarm will be canceled and the report to the monitoring station stopped. If not canceled soon enough, the monitoring service will dispatch the police. Police sirens will sound until the alarm is canceled. Ir To be on the safe side, call the monitoring service even if you think you may have canceled the false alarm in time to stop the report. Report canceled. Advent Home Navigator System 13 Security Protection Remote Phone Access Code Tampering Four incorrect attempts at entering an access code during any single operation session results in a TROUBLE indication. The system hangs up and will not allow further attempts for 24 hours or until the system has been disarmed via an on-site touchpad. Hang up and wait for 24 hours and try again or follow these steps at the premises: Steps Response Security Protection Turning Security Protection On Turning security protection on means arming the system against fire, intrusion, or other emergencies. You can arm the system to one of several levels depending on your needs throughout the day. Table 5: Arming Levels Sensors: Active Arming Levels: Off Home Night Away Silent 1. Press 1, 1, ACCESS CODE. Trouble beeps stop. SECURITY MENU; SECURITY IS OFF Indoor sensors (motion, etc. ). Outdoor sensors (door/window) Environmental sensors (smoke, heat, carbon monoxide, etc. ). * 4 4 4 4 4 4 4 4 Trouble is acknowledged and further remote phone access is allowed. Phone Line Tampering If the phone line is cut, the system responds with a TROUBLE indication. To stop the trouble beeps: Steps Response 4 4 4 4 Press * to clear trouble indication. Trouble beeps stop. Arming to Night is like arming to Away, except a few designated indoor sensors remain disarmed (hallway outside your bedroom). This would allow you to walk from your bedroom to the kitchen or bathroom at night without needing to disarm the entire system. If the phone line is still faulty, the trouble beeps will start again within 24 hours (at the daily trouble indication time). The display continues displaying a flashing * until the trouble is fixed. Ir Arming to Home Arming to Home is used when you stay indoors but will be awake and active. To arm the system to home: Steps Response SECURITY MENU; ARMING LEVEL CHANGE; ENTER YOUR CODE; TO QUIT PRESS * PARTITION/AREA X ARMED HOME; OK TO EXIT Have the phone line repaired immediately and notify the monitoring service of the situation. Equipment/Sensor Tampering Tampering with system equipment, sensors, etc. (for example, opening enclosures), results in a TAMPER TROUBLE indication and/or an alarm. Replace any open system enclosures or sensor covers and clear the tamper indication. To clear a tamper/alarm indication: Steps Response 1. Press * twice to exit. Active sensors: q q To clear a trouble indication, press *. SECURITY MENU; SECURITY IS OFF Outdoor (perimeter door and window) sensors that are not bypassed. Indoor (motion) sensors. Inactive sensors: q Arming to Away If any covers are still open, the trouble beeps will start again in 24 hours. The display continues displaying a flashing * until the trouble is fixed. Arming to Away is used when you leave and no one is supposed to be in or on the premises. 14 Advent Home Navigator System Security Protection To arm the system to away: Steps Response SECURITY MENU; ARMING LEVEL CHANGE; ENTER YOUR CODE; TO QUIT PRESS * PARTITION/AREA X ARMED AWAY; OK TO EXIT Ir 1. Press * twice to exit. Protected windows and doors must be either closed or bypassed in order for the system to arm. Bypassing A security system cannot protect an open door or window. When you attempt to turn security protection ON, the system will warn you if a door or window has been left open. You can do this automatically for just this time or manually for more than just this time. Automatically Bypassing All (except bypassed) sensors will be active following an initial exit delay. Ir Protected windows and doors must be either closed or bypassed in order for the system to arm. Arming to Night Arming to Night is used when you will be staying inside-- sleeping or inactive. Ir When you cannot turn security protection on because the system warns you about an open door/window or faulty door/window sensor. To bypass a door or window for this arming session only: Steps Response SECURITY MENU; ZONE ### IS OPEN; PRESS 1 TO ACCEPT ZONE ### BYPASSED Arming to Night is like arming to Away, except a few designated indoor sensors remain disarmed (example: hallway, kitchen, bathroom). [. . . ] Panel has detected a trouble with one of its SnapCards; SnapCard is missing or wrong type. System has taken control of (seized) the telephone lines and/or is too busy to respond now. System is about to take control of (seize) the telephone lines. 30 Advent Home Navigator System Appendix D: System Planning Tables Appendix D: System Planning Tables Below are tables to help list programmed options. Schedules Table 12: Schedules Part. # Schedule On Time Off Time Duration Normal Holiday A Holiday B Temporary Arming Type Daylight Type 1 1 Holiday Schedules Advent Home Navigator System 31 Appendix D: System Planning Tables Table 13: Holiday Schedule Partition # List Holiday # Month Day Normal 32 Advent Home Navigator System FCC Notices FCC Part 15 Information to the User Changes or modifications not expressly approved by Interlogix, Inc. [. . . ]