User manual IROX XLP

[. . . ] Features: Altimeter - 1 meter (or foot) resolution and with working range from -700 meters (-2296 feet) to 9000 meters (29520 feet). Barometer - 1 hPa resolution and with working range from 300 hPa to 1100 hPa. Compass - Electronic compass providing 16 cardinal indications together with bearing in degrees. - Presents day of the week, day, hours, minutes and seconds (year and month can also be set). [. . . ] - There are 3 displays for Barometer mode. To switch among the 3 displays for barometer mode Use A or E to switch among the 3 displays for barometer mode. 9 Reading the graph of sea level pressure The graph shows the relative changes in sea level pressure in the past with the current pressure represented on the right. Each horizontal point represents one hour while each vertical point represents the relative reading of pressure in that time. Hold down B until the unit indicator (°F or °C) stops flashing to switch temperature between °F and °C. Hold down D until "SET CURRENT WEATHER" scrolls on the display, which indicates the weather setting screen. Press C, "SET SEA LEVEL PRESSURE" scrolls on the display, which indicates reading setting screen. * If there is no button operation for 2-3 minutes at setting screen, the display will return to Barometer mode automatically. Hold down D until "SET CURRENT WEATHER" scrolls on the display, which indicates the weather setting screen. * If there is no button operation for 2-3 minutes at setting screen, the display will return to Barometer mode automatically. 10 7. - The altimeter is of 1 meter (or foot) resolution and with working range from -700 meters (-2296 feet) to 9000 meters (29520 feet). Reading the altitude graph The altitude graph shows the relative changes in altitude in the past with the current altitude represented on the right. Each horizontal point represents 15 minutes while each column represents the relative reading of altitude in that time. To switch between meters and feet Hold down B until the unit indicator (M or Ft) stops flashing to switch altitude reading between meters and feet. To store altitude data Hold down A until "DATA" stops flashing to store the current altitude data. Hold down D until the current altitude reading starts to flash on the display (Text "HOLD", then in the top line "CAL"). * If there is no button operation for 2-3 minutes at setting screen, the display will return to Altimeter mode automatically. Display of the accumulated altitude change (ACC) and the maximum measured altitude (MAX) By pressing the key A in the Altimeter-Mode, the top line in the LCD will show a moving text with the accumulated altitude changes and the highest measured altitude. In the calibration mode (see above in "to calibrate altitude reading"), you may reset the two values to zero. The relevant setting will be shown in the top line of the LCD: MAX: Press key A or B to reset the max value to zero. Press B to stop the time measurement. To clear time in current run 1. * Time in current run is cleared. Activate the Heart Rate Monitor in the CHRONO Mode - The HRM is activated automatically when you start the chronometer - When no chronometer is running, you may activate the HRM by pressing the key D - When the HRM is active, a heart icon will be shown on the display. The received pulse rate will then be shown after a few seconds in the display. - If no signal is received for about 1 minute, the HRM will deactivate itself automatically (heart icon disappears from display). [. . . ] * The alarm turns on, which is indicated by ON and the appearance of the alarm on indicator. * If there is no button operation for 2-3 minutes at setting screen, the display will return to Alarm mode automatically. To turn the alarm on and off Press A to turn the alarm on (indicated by ON) and off (indicated by OFF). * If the alarm is turned on, the alarm on indicator will be shown. 11. [. . . ]