User manual IROX RED WAVE

[. . . ] We therefore recommend that this mode of operation for the light is really only used by you in specific and exceptional cases. TR: Every time the display is touched lightly, the display lighting is switched on for approx. Rocker-switch contact of the display The display (LCD) is mounted in the device via a rocker-switch contact that you can also activate by lightly pushing the display backwards. With each touch, the display mode changes to the following sequence: TIME TEMPERATURE DATE AL (Alarm) TIMER - The `M' key on the underside has the same function when pressed briefly. [. . . ] - With the rocker-switch contact, a setting can be cancelled at any time. Note: In the backlight mode `TR' the display lighting is switched on the first time the appliance is touched lightly. 6 seconds during which the display lighting is active, you can scroll through in display mode with each touch as described above. 3. Switch `Return to time' on the underside ON: If no manipulation to the device is made after selection of a display mode with the rocker-switch contact, the display automatically changes back to the time display. Keys on the underside M ­ same function as the display rocker-switch contact S ­ pressed briefly: To change the display in the corresponding display mode or to activate a function ­ pressed for a long time (approx. 2-3 seconds): To make a setting in the corresponding display mode (the segment to be set flashes in each case in the display) / ­ In the setting mode, the two keys are used to change the value to be set. > Details about the keys can be found in the corresponding function description 4- TIME SETTING (in the display mode TIME) 1. Press the `S' key briefly on the underside of the device in order to select the 12/24-hour display format. - The flashing hours number can be set with the upwards `' or downwards `' key. The flashing minutes number can be set with the upwards `' or downwards `' key. In order to allow the timer to continue running, press the `S' key again. When the timer is stopped, you can also move back to the time set with the upwards key `' or with the downwards key to zero. When the time has expired, the alarm sound `beep' sounds out for 60 seconds and the display flashes in different colours. The alarm sound can be interrupted at any time using the rocker-switch contact of the display. If this is not done, the alarm sound can be interrupted when the 60 seconds have expired and the prior timer time appears, ready for a restart, on the display. 8- DISPLAY MODE OF THE TEMPERATURE (in the display mode TEMPERATURE) Press the `S' key to change the temperature unit from °C to °F and vice versa. 9- MELODY SELECTION (in each display mode apart from TIMER) In the time mode, press the upwards `' or downwards `' key to select one of the 8 melodies. If you do not wish this, go into the AL mode and select the '9th melody' as described here: the simple `BEEP' tone. 10- CARE INSTRUCTIONS - Do not expose the device to extreme temperatures or direct sunlight over longer periods. - For cleaning use a dry soft cloth that you have moistened with water and a mild cleaning agent. Never use volatile substances such as benzene, thinner, cleansing agents in spray cans etc. - When your clock is not being used store it in a dry area and out of the reach of small children. [. . . ] - When your clock is not being used store it in a dry area and out of the reach of small children. - If the alarm clock is activated under extreme coldness it may occur that the display becomes illegible. As soon as the clock is returned to a warm environment the device will function normally. - Please keep the user's manual and other documents delivered with the device stored carefully so that you can reference them at a later point if necessary. [. . . ]