User manual IROX PHAN X

[. . . ] ­ The time mode shows weekday, hours, minutes and seconds (12 or 24-hour format selectable). ­ Calendar display with weekday, month and day for the years 2000­2039. [. . . ] Transmitter electrodes should be moistened to ensure flawless heart rate measurement. It is recommended that you wear the transmitter against your bare skin to ensure flawless operation. 3. 5 Measuring the pulse 58 ­ Press S3 to show Pulse mode, mode prompt "PULS" will be displayed for 1 second first. ­ Heart icon flashes when heart rate signal is received from the transmitter and the heart rate is shown at the middle row of the display. ­ If zone alarm is set to "on", 1 "Beep" sound will be given every 6 seconds when heart rate is below "Zone Low Limit" and 2 "Beep" sounds will be given every 6 seconds when heart rate is above "Zone High Limit". If no heart rate signal is received for 1 minute, the link between the watch and the transmitter will be cut off automatically, and "---" (not flashing) will be shown at the middle row of the display. To re-link, press S1, and "---" will start flashing or heart rate will be shown. If zone alarm is set to "off", there will be no zone alarm or high/low limit indication. 59 3. 6 Stopwatch ­ Press S3 to show Chronograph mode, mode prompt "Chro" will be displayed for 1 second first. ­ Heart icon flashes when heart rate signal is received from the transmitter and the heart rate is shown at the top row of the display. ­ The chronograph shows seconds and 1/100-seconds (at the bottom row) up to 1 minute, then shows minutes, seconds and 1/100-seconds (at the bottom row) up to 1 hour, and then shows hours, minutes and seconds (at the bottom row). 60 ­ If zone alarm is set to "on", 1 "Beep" sound will be given every 6 seconds when heart rate is below "Zone Low Limit" and 2 "Beep" sounds will be given every 6 seconds when heart rate is above "Zone High Limit". And the displays will be as follow: ­ Press S1 again to take split time, the taken split time will be shown for 10 seconds (with characters "CHR" flashing), and then the display will show current running time of chronograph. ­ Press S2 to stop the chronograph, then press S1 to re-start the chronograph or press S2 to reset the chronograph back to zeros. [. . . ] Remark If there is no button operation for 2­3 minutes in setting mode, the watch will return back to Time mode automatically. 3. 8 Reset the watch Press and hold S1, S2 and S3 simultaneously for 1 second, all segments will be "off", then release the buttons and the watch will be reset. [. . . ]