User manual IROX HBR555T

[. . . ] Though the remote units are weather proof, they should be placed away from direct sunlight, rain or snow. 2d) LOW BATTERY WARNING If it's time to replace batteries for the remote sensors or the unit, the respective low-battery indicator [ ] will show up on the outdoor temperature display (for the thermo/hygro sensor) or on the clock display (for the unit). When batteries are installed, the display will shows the "hPa" and "mBar". [. . . ] Fogies not indicated by the weather station as this can occur with different weather conditions. If you travel with become impossible due to changes in altitude and location. You'll have to wait up to 24 hour so that the weather station can calculate a new forecast based on the conditions at the new location. 3b) BAROMETRIC PRESSURE TREND The atmospheric pressure indicator, in the weather forecast window, uses arrows to indicate if the atmospheric pressure is increasing, remaining stable, or decreasing. 4a) HOW TO CHECK REMOTE AND INDOOR TEMPERATURES The wave display on the outdoors temperature indicates the reception of the remote unit is in good order. If no readings are received from the remote unit for more than two minutes, blanks " " will be displayed until further readings are successfully searched. You can wait for a little while or Hold [ ] for 2 seconds to enforce an immediate search. If the temperature or humidity goes above or below than the measuring range of the main unit or the remote unit (stated in specification), the display will show " " & "HHH" or "LLL" respectively. The unit can be set to automatically scan and display readings from the remote sensors, the display will show the readings from one channel for about 4-seconds and then proceed to the next channel display. To display them, Press [ MEM ] once to display the maximum readings and again the minimum readings. If you press [ MEM ] now, the maximum and minimum readings will have the same values as the current ones until different readings are recorded. 4d) TEMPERATURE ALARM Weather Station is equipped with a temperature alarm whereby a user-defined temperature can be selected. With one further pressing of the TEMP ALARM button the data entered is confirmed. 4f) COMFORT LEVEL INDICATORS The comfort level indicators COM, WET or DRY will tell you if the current environment is comfortable, too wet or too dry. The comfort indicators will appear on the display of the main unit when the following conditions are satisfied: Indicator displays on the unit COM Temperature Range 20°C to 25°C (68°F to 77°F) -5°C -+ 50°C (23°F - 122°F) -5°C -+ 50°C (23°F - 122°F) Less than 20°C (68°F) or More than 25°C (77°F) 72 Humidity Range 40%RH70%RH OVER 70%RH Below 40%RH 40%RH to 70%RH Shows that the Current Environment Ideal range for both relative humidity and temperature Contains excess moisture Contains inadequate moisture No comment After the batteries are installed. To enable the auto-reception feature again, holds the "Up" for 2 seconds again to force it receive and allow it receive at desired time. [. . . ] Do not subject the unit to excessive force, shock, dust, temperature or humidity, which may result in malfunction, shorter electronic life span, damaged battery and distorted parts. Doing so will invalidate the warranty on the unit and may cause unnecessary damage. Always read the user's manual thoroughly before operating the unit. [. . . ]