User manual IROX HBR425I

[. . . ] Or you can remove the stand and mount the unit on a wall using the recessed screw hole. Once batteries are in place for the remote unit, they will start transmitting temperature and humidity readings at around 45 seconds intervals. [. . . ] You'll have to wait up to 24 hour so that the weather station can calculate a new forecast based on the conditions at the new location. 4a) HOW TO CHECK REMOTE AND INDOOR TEMPERATURES The wave display on the outdoors temperature indicates the reception of the remote unit is in good order. If no readings are received from the remote unit for more than two minutes, blanks " " will be displayed until further readings are successfully searched. You can wait for a little while or Hold [ ] for 2 seconds to enforce an immediate search. If the temperature goes above or below than the measuring range of the main unit or the remote unit (stated in specification), the display will show " "& "HHH" or "LLL" respectively. The unit can be set to automatically scan and display readings from the remote sensors, the display will show the readings from one channel for about 4-seconds and then proceed to the next channel display. To display them, Press [ MEM ] once to display the maximum readings and again the minimum readings. If you press [ MEM ] now, the maximum and minimum readings will have the same values as the current ones until different readings are recorded. 4f) COMFORT LEVEL INDICATORS The comfort level indicators COM, WET or DRY will tell you if the current environment is comfortable, too wet or too dry. The comfort indicators will appear on the display of the main unit when the following conditions are satisfied: Indicator displays on the unit COM Temperature Range 20°C to 25°C (68°F to 77°F) -5°C -+ 50°C (23°F - 122°F) -5°C -+ 50°C (23°F - 122°F) Less than 20°C (68°F) or More than 25°C (77°F) 68 Humidity Range 40%RH70%RH OVER 70%RH Below 40%RH 40%RH to 70%RH Shows that the Current Environment Ideal range for both relative humidity and temperature Contains excess moisture Contains inadequate moisture No comment After the batteries are installed. To enable the auto-reception feature again, holds the "Up" for 2 seconds again to force it receive and allow it receive at desired time. If the radio signal is received, the date & time will be set automatically with radio control signal icon [ ] turns on. Each press on the [MODE] button will change the display between clock with second, clock with day of week, zone time with day of week. Repeat the same procedure to set °C/°F, year, month, date, date-month format, 12/24, hour and minute. [. . . ] Doing so will invalidate the warranty on the unit and may cause unnecessary damage. Always read the user's manual thoroughly before operating the unit. [. . . ]