User manual IROX AQUA

[. . . ] Remote sensor battery low indicator Appears when the batteries of the remote sensor are running dry and the temperature or humidity measured by this sensor is no longer reliable. Barometric history indicator Indicates the recorded air pressure reading in the past 24 hours L . Barometric pressure window Displays the barometric pressure reading in mb hpa or inHg. Barometric pressure chart Shows the barometric pressure trend chart for the past 24 hours N . [. . . ] Push the battery compartment back, turn the metal nut clockwise to lock; Note: Replace the batteries when the low battery indicator appears on the top-right corner of the LCD. Insert x4 AA batteries first to the main unit, the temperature display shows - - . ­ While the wave icon will keep blinking for 2 minutes indicate unit is in sensor searching mode. The LED on the front panel will start flashing at a rate of one time per around 2 seconds indicates channel-1 is in use. While the LED is flashing, press once the [CH] key will change the sensor channel setting to 2. Note: If user does not press any key for 10 seconds, it will exit the channel setting mode and transmit the RF signal. (If the transmitter has the LCD display, the °C/°F key will toggle the temperature unit on the LCD. While the auto-scroll function is set, the unit will automatically cycle to display the temperature and humidity of each remote sensor for 6 seconds. To retrieve manually the specific sensor temperature and humidity reading, press CHANNEL key until desired channel number is displayed. Until auto scroll icon appears on the left hand corner of the 3rd line display. The built-in radio controlled clock is designed to synchronize the time automatically once the unit is brought within the range of the Frankfurt DCF 77 radio signal. When the unit is receiving the signal, the radio reception " " icon will start flashing and during this reception all manual settings are disabled. The time reception may take, depending on the signal strength, up to 10 minutes. When the time reception is complete, the " " " " " " icon will stop blinking and the following result is shown: You may start a new reception manually. If you wish to disable the time reception while it is active in order to perform an operation on the unit, press the [ ] button. Press & hold [CLOCK] button for 2 seconds to enter clock setting mode. Press [ ] or [ ] button to switch between 24 hours and 12 hours format, and then press [CLOCK] button to confirm. Use the [ ] button to increase by one hour or [ ] button to decease by one hour to your desired hours. Note: The month phase and the weekday will be automatically calculated and dis played for the date set above. Press [CLOCK] button to confirm and exit setting mode Note: If no key press during setting mode for 10 seconds, it will automatically keep the setting and exit to normal display. Press and hold [alarm] button for 2 seconds to enter alarm setting mode. The hour digits will flash, use [ ] button to increase by one hour or [ ] button to decease by one hour to your desired hours. [. . . ] Our weather station requires entry of elevation in meter and in foot separately. To enter the altitude compensation setting mode, press and hold [HISTORY] button for 2 seconds to switch from Barometric Pressure to Altitude adjust mode for 10 seconds and the meter icon flashes. During Altitude adjust mode, press [UNIT] button to toggle between meter and foot unit. Our weather station is equipped with barometer reading for 24hr history. [. . . ]