User manual ION SLIDES 2PC MK III

[. . . ] FCC NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. [. . . ] On the window that appears after you insert the disc, click "Install Software. " If this window does not automatically appear, double-click "My Computer" then double-click the name of the CD. If the window still does not appear, right-click the name of the CD and select "Explore. " Once the CD's contents are shown, double-click "Install. Insert the installation CD into the CD-ROM drive and the click the CD icon. Insert the slide(s) into the slide slot(s) or lay the negative over the negative slot. Insert one end of the roll of film in the slot on the right-hand side of the holder. Gently push/pull the roll of film through the holder to move from picture to picture. Tip: To avoid laying a negative in the wrong direction (which will produce a mirror image), be sure you can correctly read the serial numbers at the top of the negative when placing it in the holder. With the lever all the way to the right, stack your slides in the rapid slide feeder. Push the lever towards the left, then pull the lever back to the right again to load a slide from the feeder into SLIDES 2 PC. Repeat this step for subsequent slides (which will push the used slides out the other side). 5 USING THE SLIDES 2 PC 1 Plug the USB cable of the SLIDES 2 PC into your computer’s USB port. Note for Windows users: The first time you connect SLIDES 2 PC to your computer, wait a few seconds until you see a dialog box that says "Found New Hardware" (this means the computer recognizes the SLIDES 2 PC). 2 Insert the loaded film / slide holder properly into the slot as shown. Click the "folder" icon button and select the location to save your pictures. 6 or Click “Snapshot” on the screen or press the COPY button on SLIDES 2 PC. Press the “Save” button to save the pictures to your computer. [. . . ] Several photo adjusting software applications are available to "clean-up" your newly digitized picture. The slide or film might not be properly inserted in the holder, or the holder might not be fully inserted into the SLIDES 2 PC. Remove the holder from SLIDES 2 PC and make sure the slide or film is placed correctly in the holder. [. . . ]