User manual ION QUICKPLAY LP

[. . . ] Li QUICK PLAY LP USB-POWERED LP-TO-MP3 TURNTABLE QUICKSTART GUIDE ENGLISH ( 3 – 4 ) MANUAL DE INICIO RÁPIDO ESPAÑOL ( 5 – 6 ) GUIDE D’UTILISATION RAPIDE FRANÇAIS ( 7 – 8 ) GUIDA RAPIDA ITALIANO ( 9 – 10 ) KURZANLEITUNG DEUTSCH ( 11 – 12 ) SNELSTARTGIDS NEDERLANDS ( 13 – 14 ) QUICKSTART GUIDE o Make sure that the items listed below are included in the box: QUICK PLAY LP CD USB cable Slipmat Quickstart Guide Safety Instructions & Warranty Information READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT Go to http://www. O o INTRODUCTION You should install EZ Vinyl/Tape Converter to take advantage of computer recording. EZ Vinyl/Tape Converter is the quickest and easiest way to turn your recordings into digital media. [. . . ] (Please note: you can still copy music to a CD or to your computer even if the audio outputs of the turntable are not connected to a stereo system). You may damage your receiver if you plug in a LINE-level into a PHONO input. Tonearm – QUICK PLAY LP comes with a ready to use pre-balanced tonearm and cartridge. The 5 tonearm can be raised and lowered by hand, or by pressing the raise / lower lever. Please note that the tonearm needs to be moved away from resting position (on the arm clip) for the turntable motor to activate. When the tonearm is placed back in its resting position, the turntable motor will deactivate. Arm Clip – This specially designed arm clip secures the tonearm while at rest or when not in use. The arm IMPORTANT: Remove the plastic cartridge cover (needle clip has been designed to remain in the up position cover) before operating the turntable. When autostop is on, the platter will start spinning when the tonearm is placed over the record and stop spinning when the record has reached the end. (When autostop is off, the platter will always spin regardless of the position of the tonearm. ) Note: If your record stops before a song is done playing, set the Autostop Switch to "off. " 33 / 45 / 78 RPM Switch – This switch controls the RPM of the turntable platter. You may damage your receiver if you plug in a LINE-level into a PHONO input. TROUBLESHOOTING PROBLEM I am not hearing any audio when I am recording. Make sure that the turntable is connected to a computer that is powered on. Cartridge must be securely connected to the tonearm whenever you are using the turntable. [. . . ] " Click OK to close the Properties window, then click OK to close the Sound control panel. When recording into my computer on Windows 7, music is distorted or "clipping. If you are playing a 45RPM record, the Autostop feature may have detected that the tonearm is close enough to the center to stop the record. [. . . ]