User manual ION ILP

[. . . ] To listen to a record while it's playing, connect iLP's RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs; iLP's RCA outputs are line-level and could damage a device with phono-level inputs. 2 USING iLP WITH YOUR COMPUTER RECORDING To record music to your computer, you can use ION EZ Vinyl/Tape Converter. EZ Vinyl/Tape Converter conveniently saves your recordings in your iTunes® library. [. . . ] Arm Clip – This specially designed arm clip secures the tonearm while at rest or when not in use. The arm clip has been designed to remain in the up position while unlocked. 33 / 45 / 78 Switch* – This switch controls the RPM of the turntable platter. When autostop is on, the platter will start spinning when the tonearm is placed over the record and stop spinning when the record has reached the end. (When autostop is off, the platter will always spin regardless of the position of the tonearm. ) Dock – Connect your iOS device (not included) here to record audio to it from your vinyl. Please see the USING iLP WITH YOUR iPhone, iPad, or iPad touch section of this manual for information on compatible iOS devices and how to record to them. RCA Output** – The audio from a playing vinyl record is sent to this line-level coaxial audio output. USB Audio Output – Use the included USB cable to connect your turntable to your computer. The USB connection will send audio from the turntable to your computer. Please see the USING iLP WITH YOUR COMPUTER section of this manual for information. 9 DC 12V 1A 10 11 Mac/PC 12 IMPORTANT: Remove the plastic cartridge cover (needle cover) before operating the turntable. You may damage your receiver if you plug in a LINE level device into a PHONO level input. On the underside of iLP, remove the rubber pads and tighten/loosen the appropriate screw with a screwdriver. 4 TROUBLESHOOTING If you experience any difficulties, please refer to the troubleshooting steps below as well as those in the EZ Vinyl/Tape Converter manual included with this product. I'm not hearing any audio when recording: • If you are recording to an iOS device: o Make sure that iLP is powered on and that the needle is on the record. o Connect iLP's RCA outputs to a stereo system or powered speakers. (Do not connect them to phono-level inputs; iLP's RCA outputs are line-level and could damage a device with phono-level inputs. ) o Make sure iLP is not connected to your computer's USB port, then "power cycle" iLP (turn it off then on again). € If you are recording to a computer: o Make sure that iLP is powered on and that the needle is on the record. O Make iLP is selected as your computer's default recording device (see the instructions below). O If you are listening through your computer's speakers, make sure those speakers are selected as your computer's default playback device (see the instructions below). [. . . ] Click the Playback tab and select your computer's soundcard as the default device. Mac: Click the upper-left "apple" icon then click System Preferences Sound. From the menu, select Internal Speakers if you are using the computer's internal speakers or select Headphones if you are using speakers or headphones attached to the computer's 1/8" headphone output. sETTING iLP AS THE DEFAULT RECORDING DEVICE • • • • Windows XP: Click Start Menu Control Panel (or Settings Control Panel in Classic View) Sound and Audio Devices. [. . . ]