User manual INTERMATIC WL150HPS

[. . . ] HID Wall Pack - WL Series INSTALLATION INSTRUCTIONS Lamp Types: High Pressure Sodium 150 Watt Model: WL150HPS IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES ELECTRICAL REQUIREMENTS A qualified electrician should complete all required wiring. This fixture will accept 120, 208, 240 or 277 volts AC and must be properly grounded for safety. [. . . ] If supply voltage is lower, cap wire marked 277V with appropriate twist on wire connector and strip fixture wire marked with matching voltage. (See Figure 3) 240 V 277 V X3 IGN-01 X1 CAP 208 V 120 V COM LAMP Figure 3 COM X3 5. Feed the matching voltage fixture wire, fixture wire marked "COM", and bare copper fixture grounding wire out of the fixture. Confirm all unused voltage fixture wires are appropriately capped within fixture body. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires. Connect the selected voltage fixture wire to the Black (hot) supply wire. Connect the White fixture wire marked "COM" to the White (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. Install, close, and secure lens cover with (2) screws making sure that the gasket is properly seated. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. To operate, restore power to the circuit and switch light on. LAMP REPLACEMENT CAUTION: Use lamp of correct type and wattage as specified on fixture. 1. Remove old lamp and replace with new lamp of correct type and wattage. Close and secure lens door, making sure that gasket is properly seated, free of debris, and compressed to seal out moisture. Properly dispose of lamp per manufacturer's recommendations. If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. [. . . ] This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. LIMITED 1 YEAR WARRANTY THESE INSTRUCTIONS DO NOT COVER ALL VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR ALL SITUATIONS RELATED TO FIXTURE INSTALLATION, OPERATION OR MAINTENANCE. FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com 158HL12509 [. . . ]