User manual INTERMATIC WL070HPSPC

[. . . ] HID Wall Pack - WL Series INSTALLATION INSTRUCTIONS Lamp Type: High Pressure Sodium 70 Watt Models: WL070PSPC IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES ELECTRICAL REQUIREMENTS A qualified electrician should complete all required wiring. This fixture is for use with 120V AC only and must be properly grounded for safety. [. . . ] Fasten the rear housing to the outlet box using the screws supplied with the outlet box. Optional bottom conduit entrance - Drill out and tap recessed indentation in the bottom of rear housing. To weather proof the fixture, be sure to seal all holes in fixture housing (mounting conduit, plugs, photo controls, etc. ) with silicone sealant. Fixture lens cover Screw Screw Screws Reflector Figure 1 Grounding Screw Conduit Entry Ground Lead Figure 2 Photocontrol Knock-out 4. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires as follows: (See Figure 5) a. Connect the supply grounding wire to the fixture by hooking it around the green grounding screw between the brass washer and screw head. Tighten the screw securely. X3 X1 IGN-01 120 V COM LAMP Figure 3 Black Figure 4 White 5. 8. LAMP REPLACEMENT Replace reflector; secure it with (2) screws. To operate, restore power to the circuit and switch light on. Figure 5 COM X2 If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. [. . . ] Properly dispose of lamp per manufacturer's recommendations. LIMITED 1 YEAR WARRANTY CAUTION: Use lamp of correct type and wattage as specified on fixture. THESE INSTRUCTIONS DO NOT COVER ALL VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR ALL SITUATIONS RELATED TO FIXTURE INSTALLATION, OPERATION OR MAINTENANCE. FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com 158HL12122 [. . . ]