User manual INTERMATIC T1905

[. . . ] This fixture is for use with 120V AC only and must be properly grounded for safety. A mounting suitable for outdoor use and rated for wet locations is required. [. . . ] Follow all applicable electrical codes and regulations. WARNING: Electric shock hazard WARNING: Fire hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc. ) might collect. Avoid locations where humans or animals might accidentally touch fixture. WARNING: Explosion hazard WARNING: Explosion hazard MOUNTING & WIRING CAUTION: Never operate light without securing the lens. Screw the threaded mounting arm of the fixture into 1/2" NPS mounting hole on mounting device. (See Fixture 1) Mount the fixture so lamp is horizontal to prolong lamp life. (See figure 2) Clip Mounting Arm Bolt Locknut Spring Loaded Contact Clip Figure 1 Figure 2 Install with lamp horizontal 2. Using provided twist on or other approved connectors, connect the fixture wires to the supply wires as follows: (See Figure 3) a. Connect the bare copper (fixture ground) wire to the supply grounding wire. (BLACK) SPRING LOADED CONTACT (WHITE) COM 120 V Figure 3 3. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-6757000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. Turn off power at circuit breaker or fuse box. Remove old lamp, pushing lamp towards the spring loaded contact first. Rotate lamp back and forth in place about the long axis to seat contacts. [. . . ] Rotate lamp back and forth in place about the long axis to seat contacts. Replace lens and secure clips, making sure that gasket is in place and compressed to seal out moisture. [. . . ]