User manual INTERMATIC T171CR

[. . . ] This fixture will accept 120 Volts AC and must be properly grounded for safety. A mounting suitable for outdoor use and rated for wet locations is required. [. . . ] Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc. ) might collect. Avoid locations where humans or animals might accidentally touch fixture. WARNING: Explosion hazard Never operate light without securing the lens door. When light is operating, the gas in the lamp inner arc tube is at high pressure. Never operate light if the fixture lens or outer glass envelope of the lamp is broken or missing. WARNING: Explosion hazard Wear safety glasses and gloves when handling lamp, High Pressure Sodium outer envelope is under vacuum and could implode. Screws Mounting Plate Lens Cover Locknut Inside Fixture Figure 1 HINGE Figure 2 MOUNTING & WIRING 1. Apply provided gasket to back of mounting plate for sealing against junction box. X3 X1 IGN-01 120 V COM LAMP 5. Feed the matching voltage fixture wire, fixture wire marked "COM", and bare copper fixture grounding wire through the locknut and then out of the fixture. Properly dispose of lamp per manufacturer's recommendations. CAUTION: Use lamp of correct type and wattage as specified on fixture. If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. [. . . ]