User manual INTERMATIC FL150Q

[. . . ] Quartz Flood Light - FL Series INSTALLATION INSTRUCTIONS Lamp Type: Tungsten Halogen 150 Watt Model: FL150Q IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES ELECTRICAL REQUIREMENTS Read instruction sheet carefully before installing fixture. Retain instructions for future reference. A qualified electrician should complete all required wiring. [. . . ] Connect the bare copper (fixture ground) wire to the supply grounding wire. (BLACK) SPRING LOADED CONTACT (WHITE) COM 120 V Figure 3 3. 6. AIMING FIXTURE Make sure that all wires and connections are inside the mounting wiring compartment and that the cover is properly sealed to keep moisture out. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. Once inserted, rotate lamp back and forth in place about the long axis to seat contacts. Replace lens and secure clips, making sure that gasket is in place and compressed to seal out moisture. To operate, restore power to the circuit and switch light on. WARNING: Electric shock hazard. 1. 3. Do not turn mounting arm more than 360° after wires are connected. Excessive twisting of wires may loosen connections. LAMP REPLACEMENT 1. Loosen mounting arm bolt (do not remove) and tip fixture to desired angle. If adjustment is needed, turn power OFF at circuit breaker or fuse box and allow fixture to cool before adjusting. If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. [. . . ] Properly dispose of lamp per manufacturer's recommendations. LIMITED 1 YEAR WARRANTY CAUTION: Use lamp of correct type and wattage as specified on fixture. THESE INSTRUCTIONS DO NOT COVER ALL VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR ALL SITUATIONS RELATED TO FIXTURE INSTALLATION, OPERATION OR MAINTENANCE. FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com 158HL12454 [. . . ]