User manual INTERMATIC FL150HPS

[. . . ] HID Flood Light - FL Series INSTALLATION INSTRUCTIONS Lamp Types: High Pressure Sodium 150 Watt Model: FL150HPS IMPORTANT: FOR OUTDOOR USE ONLY NOT FOR USE IN HAZARDOUS ATMOSPHERES ELECTRICAL REQUIREMENTS A qualified electrician should complete all required wiring. This fixture will accept 120, 208, 240 or 277 volts AC and must be properly grounded for safety. A mounting suitable for outdoor use and rated for wet locations is required. [. . . ] Using provided twist on or other approved connectors, connect the fixture wires to the supply wires as follows: a. All fixtures are shipped with appropriate twist on wire connector and strip fixture wire marked with matching voltage. Confirm unused voltage fixture wires are appropriately capped within fixture body. Replace and secure reflector in the same orientation as shown in Figure 2. Close and secure lens door to prevent damage while wiring fixture to mounting. Connect the fixture wire matching the incoming voltage to the black (hot) supply wire. Connect the fixture wire marked COM to the white (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. 240 V 277 V X3 IGN-01 X1 LAMP CAP 208 V 120 V COM 3. 4. 6. Figure 3 Make sure that all wires and connections are inside the mounting wiring compartment and that the cover is properly sealed to keep moisture out. Close lens door, making sure that gasket is in place and compressed to seal out moisture. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photocontrols, etc. ) with silicone sealant. To operate, restore power to the circuit and switch light on. COM X3 AIMING FIXTURE WARNING: Electric shock hazard. 1. Loosen mounting arm bolt (do not remove) and tip fixture to desired angle. If adjustment is needed, turn power OFF at circuit breaker or fuse box and allow fixture to cool before adjusting Do not turn mounting arm more than 360° after wires are connected. Excessive twisting of wires may loosen connections. LAMP REPLACEMENT CAUTION: Use lamp of correct type and wattage as specified on fixture. 1. Remove old lamp and replace with new lamp of correct type and wattage. [. . . ] This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. LIMITED 1 YEAR WARRANTY THESE INSTRUCTIONS DO NOT COVER ALL VARIATIONS IN EQUIPMENT, NOR DO THEY PROVIDE FOR ALL SITUATIONS RELATED TO FIXTURE INSTALLATION, OPERATION OR MAINTENANCE. FOR FURTHER INFORMATION CONTACT YOUR DISTRIBUTOR OR INTERMATIC INCORPORATED - SPRING GROVE, ILLINOIS 60081 (815) 675-7000 www. intermatic. com 158HL12117 [. . . ]