User manual INTERMATIC FL100MH

[. . . ] Follow all applicable electrical codes and regulations. Read instruction sheet carefully before installing fixture. Retain instructions for future reference. WARNING: Electric shock hazard Disconnect power at circuit breaker or fuse box before installing or servicing light. WARNING: Explosion hazard Never operate light without securing the lens door. [. . . ] Close and secure lens door to prevent damage while wiring fixture to mounting. Connect the fixture wire matching the incoming voltage to the black (hot) supply wire. Connect the fixture wire marked COM to the white (neutral) supply wire. Connect the bare copper (fixture ground) wire to the supply grounding wire. 240 V CAP 277 V X3 IGN-02 X1 208 V 120 V COM LAMP 3. Make sure that all wires and connections are inside the mounting wiring compartment and that the cover is properly sealed to keep moisture out. To weatherproof fixture, seal all holes in housing (mounting conduit, plugs, photo controls, etc. ) with silicone sealant. Close lens door, making sure that gasket is in place and compressed to seal out moisture. To operate, restore power to the circuit and switch light on. Figure 3 COM X2 CAUTION: (Metal Halide Lamps Only) Do not use lamp beyond manufactures rated life to reduce chance of lamp rupture. AIMING FIXTURE WARNING: Electric shock hazard. Do not turn mounting arm more than 360° after wires are connected. Excessive twisting of wires may loosen connections. Turn lamp off at least once for 15 minutes per week to reduce chance of lamp rupture. LAMP REPLACEMENT 1. [. . . ] Remove old lamp and replace with new lamp of correct type and wattage. Close and secure lens door, making sure that gasket is properly seated, free of debris, and compressed to seal out moisture. [. . . ]