User manual INTERMATIC ART589A

[. . . ] ALWAYS TURN POWER OFF AT THE SERVICE PANEL BY REMOVING A FUSE OR CIRCUIT BREAKER BEFORE DOING ANY CIRCUIT REPAIRS. RESET button - push the RESET button with a ball point pen to clear all 6 7 8 9 10 11 programming and the clock. TIME SET button push and hold to set the clock in On, Auto or Off modes. ON/OFF button - push and release to manually switch on or off at any time. [. . . ] Seconds are set to 0 when the TIME SET button is released if either the HOUR or MIN have been set. HB77 /ART589A 3/26/04 2:10 PM Page 2 RESET MODE Push and release MODE to change the mode. The modes are Countdown timer, Off, Auto, On, and Rand. TIME SET manually override the program and turn the plugged in light(s) on or off. The timer stays in auto mode. ON/OFF DAY HOUR MIN DS PROG MODE On mode In the On mode the plugged in light(s) are on. Push ON/OFF button to turn the plugged in light(s) off and switch the mode to Off. TH AM On Note: In case of a conflict (for example you have programmed the timer to be on at 4 pm every day of the week and also programmed the timer to be off at 4 pm on saturdays) the higher program number is followed. In case of a conflict within a program number Off is followed rather than On. Battery replacement Batteries retain the program during power outages. Batteries should last 3 years or more if the timer is left plugged in. If the display is dim, weak or unreadable when the timer is unplugged from the outlet replace the batteries. Note: Without batteries the HB77 will save the program for only 15 seconds. Plenty of time if new batteries are already unwraped, and in + - polarity postion. Reprogram the HB77 if needed. FULL ONE YEAR WARRANTY If within one (1) year from date of purchase, this product fails due to a defect in materials or workmanship, Intermatic Incorporated will repair or replace it free of charge. The warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping; (b) units which have been subject to unauthorized repair, opened, taken apart; (c) units not used in accordance with directions; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. This warranty service is available by either: a) returning the product to the dealer from whom the product was purchased or (b) mailing postage prepaid to the authorized service station listed below. Be sure to wrap the product securely when mailing to avoid shipping damage. This warranty is made by Intermatic Incorporated, Spring Grove, Illinois, 60081-9698. AUTHORIZED SERVICE STATION INTERMATIC INCORPORATED INTERMATIC PLAZA SPRING GROVE, ILLINOIS 60081-9698 ART 589A MODE bc In countdown timer mode the clock symbol is displayed (a). [. . . ] See Auto how to program the timer, below for how to enter or change the automatic program times. You can push ON/OFF button while in Auto mode to How to program the timer: You can program the timer in Auto, On or Off modes. Prg 1 is displayed AM and the display shows Prg ­ ­ : ­ ­ or the programmed time for Auto Prg 1. ­ ­ : ­ ­ display means there is nothing programmed for that Prg number and on / off time. [. . . ]