User manual INTERMATIC 158WF12660REF

[. . . ] To decrease flow, move the switch toward min. GENERAL INSTRUCTIONS FOR WATERFALL USE WF401 CAUTION: This pump has been evaluated for use with water only. NOTE: It is recommended the pump be set at its highest flow during assembly and later adjusted to a lower setting if desired. Be sure to unplug pump before adjusting flow setting. WARNING: RISK OF ELECTRICAL SHOCK WARNING: RISK OF FIRE · Do not connect to any voltage other than that shown on the pump. [. . . ] WARNING: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS: · Turn off/unplug and allow to cool before replacing lamp. · Do not operate the luminaire fitting with a missing or damaged shield. · Do not touch hot lens. 10W 4 NOTE: Do not let pump run when NOT submerged in water. Tapwater will create mineral deposits that will result in the corruption of the Waterfall and pump. NOTICE: Do not place outdoors in weather conditions below 32°F, may cause water to freeze. Turn pump on to verify flow making sure it is not too high and everything is operating correctly. NOTE: Ensure that the electrical cord loop below the electrical outlet. " This will prevent water from running down the cord into the electrical outlet. 1. We recommend using distilled water with this product. MAINTAINING CLEANLINESS AND LIFE OF WATERFALL & PUMP Motorhead Impeller 2. Periodically change water and clean the structure of the waterfall with a mixture of vinegar and cold clean water. Add water to waterfall periodically to keep water level at an optimum level (approximately 1/2" above pump) to avoid shortening the life of the pump. Water level should completely cover pump at all times. NOTE: To clean pump, first make sure pump is UNPLUGGED from 120V circuit and remove front plate. After removing the Impeller Holder front plate, the impeller holder must be removed. Remove the Front Plate Seal Ring impeller from the pump and check for debris and/or dirt. To store waterfall after use, unplug the waterfall from the electrical outlet, empty the water, and store in a cool dry place. If jets do not spray correctly, check water level and add if necessary or clean jet holes to unclog any deposits. If pump fails to operate, check the circuit breaker, or try a different outlet to make sure the pump is getting electrical power. [. . . ] SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. LIMITED ONE YEAR WARRANTY AUTHORIZED SERVICE CENTER Intermatic Incorporated After Sales Service 7777 Winn Road Spring Grove, IL 60081-9698 158WF12660 [. . . ]