User manual INTERMATIC 158WF12659REF

[. . . ] NOTE: It is recommended the pump be set at its highest flow during assembly and later adjusted to a lower setting if desired. Be sure to unplug pump before adjusting flow setting. SLATE WARNING: RISK OF ELECTRICAL SHOCK PANEL B WARNING: RISK OF FIRE WATERFALL ASSEMBLY 1. 6. · Do not connect to any voltage other than that shown on the pump. [. . . ] Attach middle Panel B to the back of top slate piece using screws and nuts, tighten. Attach Panel C to the back of middle slate using the screws and nuts, tighten. Connect the pump and connect the power cord to the AC adapter DO NOT plug into outlet at this time. Once assembled, place the waterfall lid in base of waterfall. WARNING: NOTE: Do not let pump run when NOT submerged in water. Always submerge the pump in water first, and then plug in the unit. Place hook or nail (not included) or choose an attachment mechanism appropriate for your wall in wall and secure fountain by placing hook or nail in chain. Please ensure that product is assembled according to the directions provided in this information packet. Doing these things will increase safety measures and avoid tipping of the waterfall. 14. Tap water will create mineral deposits that will result in the corruption of the Waterfall and pump. (The waterfall is controlled by the switch on the power cord. ) If pump doesn't operate, rotate in-line switch once to turn to "off" and once to turn to "on. " NOTE: Ensure that the electrical cord loop is below the electrical outlet. " This will prevent water from running down the cord into the electrical outlet. WARNING: This is not a toy. To avoid danger of choking keep small river rocks away from Children and Pets. 1. NOTE: To clean pump, first make sure pump is UNPLUGGED from 120V circuit and remove front plate. Reassemble. MAINTAINING CLEANLINESS AND LIFE OF WATERFALL & PUMP Impeller Holder Motorhead 2. Periodically change water and clean the structure of the waterfall with a mixture of vinegar and cold clean water. Add water to waterfall periodically to keep water level at an optimum level (approximately 1/2" above pump) to avoid shortening the life of the pump. Water level should completely cover pump at all times. Regulator Front Plate Seal Ring Impeller Shaft Suction Bracket 4. To store waterfall after use, unplug the waterfall from the electrical outlet, empty the water, and store in a cool dry place. [. . . ] INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED ABOVE. [. . . ]