User manual INTERMATIC 158SS11362

[. . . ] Warranty If within 1 year from date of purchase, this product fails due to a defect in materials or workmanship, Intermatic Incorporated will repair or replace it free of charge. This warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping; (b) units which have been subject to unauthorized repair, opened, taken apart; (c) units not used in accordance with directions; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. [. . . ] To reinstall, place battery in holder with "+" end towards the front of the timer. Insert battery and cover and push at the top so it clicks into place. LCD DISPLAY 10:00 KEYPAD Controls, Displays and Operation Cover/ Switch ­ Pressing and releasing the clear cover/switch starts the interval timing functions. LCD Display ­ Displays the word "ON" and the time remaining when counting down or displays the time being entered when setting. May also display "LOW BATTERY", "FLASH", theOFFSymbol and "noOP" when appropriate Bell (see Keypad to follow). OFF COVER/ SWITCH BATTERY COVER/ HOLDER Keypad Pull the clear cover/switch at the notch at the top edge to remove cover so you have access to the keypad. To replace the cover/switch set the bottom in first, then click in at the top. ON/OFF ­ Switches the load ON when the timer is OFF (operated by pushing the clear cover/switch) and starts the interval countdown cycle. Pressing the ON/OFF key twice in less than 1 second or operating the remote (3-way) switch twice in less than 1 second (for 3-way applications) when the load is ON, will restart the timed interval without switching off the load. Pressing and holding the ON/OFF key when the load is ON will shorten the interval that is in progress. The timer will continue counting down from the time that shows when the ON/OFF key is released. WARN ­ Selects warning by audible signal ( ), flash of lights for lighting loads (the word FLASH appears), both audible and flash, or neither. If flash is selected, the load turns off for 2 seconds, 3 minutes before the load is to switch off. If audible is selected the timer beeps every 30 seconds, starting 3 minutes before the timer is to switch off. Pressing HOLD again, pressing the ON/OFF key or operating the remote switch (for 3-way applications) switches the load off. Pressing both keys simultaneously causes the timer to sequence through the preset times of 5, 10, 15, 30 minutes and 1, 2, 4, 6, 8, 12 and 24 hours. Once a preset time has been set, it can be modified using the and/or keys individually. RESET ­ Used to reset the timer in the event it displays "noOP" or other meaningless information. Does not alter the preset time. EI40C Operation/Display/Keypad Load Maintenance WARNING!DO NOT USE THE TIMER TO TURN OFF POWER FOR MAINTENANCE (service, repairs, broken bulbs, etc. ). ALWAYS TURN OFF POWER AT THE SERVICE PANEL BY REMOVING A FUSE OR SWITCHING OFF A CIRCUIT BREAKER BEFORE DOING ANY CIRCUIT REPAIRS. OFF 23:28 OFF 23:28 Normal display when timer has timed out. [. . . ] The labels may be separated so you can use only the portions appropriate for your installation. The 3-way switch function has been designed and tested to operate reliably for up to 200 feet. This means there can be up to 200 feet of wire (one-way) between the remote (3-way) switch and the timer. For best performance, do not install 3-way switches beyond the 200 ft. [. . . ]