User manual INTERMATIC 158PE11220

[. . . ] Install this control not less than 5 feet (3 meters in Canada) from inside edge of pool. Do not exceed the maximum ratings of individual components, wiring devices, and current carrying capacity of conductors. For Control grounding, bonding, installing and the wiring of underwater lights, refer to Article 680 of the National Electrical Code or Article 68 of the Canadian Electrical Code. [. . . ] If enclosure is used for direct connection of underwater lights, refer to 1999 NEC 680-21(b), 2002 NEC 680-24(b) or CEC 68-060, 062 and 066 for further details. To install additional wiring devices inside the enclosure, first remove rectangular knockout(s) in dead front. Next, remove hex head screws in back of enclosure and install standoffs* in place of screws. Order 21T156A for a set of four (4) stand-offs and mounting hardware. 8. If external bonding is required, install a bonding lug at bottom of enclosure and bond installation according to code requirements (Order 156T11047A for Bonding Lug Kit). Testing of the installation is optional and recommended only if the desired loads are securely in place and will not be damaged by this test: a. Digital Time Clock display should fully illuminate and then start to blink 12:00 a. m. Time clock will not blink only if time has been maintained by internal battery. In case of unsatisfactory results, turn OFF power, check your wiring, refer to Troubleshooting on Page 3. The control is now ready for programming, see OPERATION section on Page 4. Figure 1 2 ACCESSORIES FLTR HTR SPA JETS AIR CLNR LITE 1 LITE 2 HIGH LOW AUX 1 AUX 2 AUX 3 W/FA PUMP 1 PUMP 2 External Wired Remote Accessory Part Number 133PE1484A The New Intermatic Wired Remote Control allows you to control your Digital Time Clock from a remote location. Included with your Wired Remote Control is a label arrangement allowing you to identify each button specific to your Pool or spa equipment pad. Your new wired remote control comes standard with 100 foot of cable and is designed to slip fit into any standard 1 1/2" conduit adapter. This remote works in conjunction with the Digital Time Clock and displays feedback information on the present state of the pool or spa equipment pad. For more information refer to instructions provided with the accessory. Freeze Probe Accessory Part Number 178PA28A The New Intermatic Freeze Probe allows you to protect your pool or spa equipment during an unexpected freeze condition. The freeze probe comes with a 10 foot cable and plugs into the back of the new Digital Time Clock. The Time Clock can be programmed to turn on each or all-individual loads at any desired outside temperature. Heater Protection (Fireman) Switch is standard with each Digital Time Clock. It comes standard with a Fireman Switch connection for your pool or spa heater. [. . . ] This warranty is extended to the original house hold purchaser only and is not transferable. this warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. [. . . ]