User manual INTERMATIC 158EI12085

[. . . ] INTERMATIC EI200 ELECTRONIC IN-WALL COUNTDOWN TIMER FEATURES: · 5-10-15-30 - Minute time ranges. · Available in White, Ivory, & Light Almond RATINGS : 15A / 120V / 1800W Resistive 8. 3A / 120V /1000W Tungsten 1/4 HP Motor Leads: Black-Line, White-Neutral, Red-Load, Green-Ground INSTALLATION 1. [. . . ] Connect white timer wire to white wires in junction WIRE FROM FIXTURE box using wire connector. If the wall switch you are replacing had separate grounding conductors connected to the GREEN screw on the switch, make sure to connect these to the green wire from the timer with a wire connector. Reconnect your electrical power. FIGURE 2 OPERATIONS Timer Mode To enter timer mode, press and release the push button (for less than 2 seconds) repeatedly to select one of the four time settings or OFF ( 5 minutes - 10 minutes - 15 minutes - 30 minutes - OFF). The illuminated LED indicates which time setting is selected and the connected load is turned ON. Timer starts counting down until time out is reached, all 5 LED's go off and the connected load turns OFF. FIGURE 1 (WHITE) HOT Hold Mode (Continuous Operation) To turn timer ON for extended periods of time, press and hold the push button for more than 2 seconds. Timer enters HOLD mode, HOLD LED turns on, and the connected load is turned ON. To exit HOLD mode press and release the push button, all 5 LED's go off and the connected load turns OFF. LIMITED 1 YEAR WARRANTY If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs. [. . . ] This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd. , Spring Grove, Illinois 60081-9698/815-675-7000 http://www. intermatic. com Please be sure to wrap the product securely to avoid shipping damage. INTERMATIC INCORPORATED SPRING GROVE, ILLINOIS 60081-9698 158EI12085 [. . . ]