User manual INTELLISENSE FG-701

[. . . ] Position the FG-701 near the farthest point of the protected glass, and point it directly at the glass-break detector. Generate a flex signal by carefully striking the glass with a cushioned tool. If both the flex and audio are received properly, the red alarm LED on the detector will light. [. . . ] The FG-1000 series test mode also turns off automatically after ten minutes. Figure 3 Red Start Button Downloaded from: http://www. guardianalarms. net Testing in the MANual Mode (Continued): 1. (See Figure 3. ) Position the FG-701 near the protected glass and point it directly at the glass-break detector. Press the red start button and the FG-701 will generate a burst of glassbreak audio. If the LED on the detector flashes, the range is acceptable for audio. If the LED does not flash, move the detector closer to the glass and try again. (On FG-1000 series detectors, the green LED will momentarily turn off. ) BATTERY ANNOUNCEMENT When the battery is low, the simulator sound will be interrupted by the word "BATTERY. " The battery should then be replaced. Do not use carbon-zinc or rechargeable Ni-Cd batteries because they don't have sufficient peak power capacity. PRODUCT SPECIFICATIONS Temperature Range Operating: 32 to 122 oF (0 to +50 oC) Storage: -4 to +140 oF (-20 to +60 oC) Battery Type: 9V Alkaline, Duracell MN1604 or equivalent Estimated Battery Life: 2500 operations (MANual mode) Output Spectral Range: 1. 5 - 16 kHz Output Level: Peak SPL of 102 dB at 1 meter, on axis Dimensions: 3. 25" W x 6. 3" H x 0. 9" D (83 mm x 160 mm x 23 mm) Weight: 8 oz. (. 23 kg) TECHNICAL NOTES When a pane of glass is broken by an impact, many variables affect the sound it produces. Depending on the type of glass, its size and thickness, type of mounting, the breaking instrument, and the force with which it is struck, the sound it produces varies. In addition, the sounds will be modified by absorptive or reflective surfaces in the room where the glass-break detector is located. While no simulator can account for all possible conditions, the sound produced by the FG-701 is carefully designed to represent the more difficult cases. The sound is an enhanced digital recording of a small pane of tempered glass broken in a controlled environment. The output level of the simulator is correlated with the original sound to insure an equivalent response in C&K detectors. In production, the acoustic output is factorycalibrated to insure uniform performance. Room characteristics greatly affect the apparent detection range indicated by the simulator. In a room with hard walls, floor, and ceiling, the audio range will be much greater than in a room with absorbing surfaces such as carpets and acoustic tiles. This is because hard surfaces reflect the sound back into the room, reinforcing it at points far from the simulator. Actual glassbreak sound is affected in the same way as the simulator sound, since it has the same frequency content and originates from the same location in the room. [. . . ] Buyer understands that a properly installed and maintained alarm may only reduce the risk of burglary, robbery, or fire without warning, but it is not insurance or a guarantee that such will not occur or that there will be no personal injury or property loss as a result. CONSEQUENTLY, SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE, OR OTHER LOSS BASED ON A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING. However, if Seller be held liable, whether directly or indirectly, for any loss or damage arising under this Limited Warranty or otherwise, regardless of cause or origin, Seller's maximum liability shall not in any case exceed the purchase price of the product, which shall be fixed as liquidated damages and not as a penalty, and shall be the complete and exclusive remedy against Seller. [. . . ]