User manual INTELLISENSE FG-1025

[. . . ] The preferred location is on the wall or ceiling directly opposite the glass. When wall mounting, mount the unit at a height of at least 6 feet (1. 8 m) to avoid accidental screening if furniture in the room is moved. Curtains, blinds and other window coverings will absorb energy from breaking glass. In these cases, mount the unit on the window frame behind the window covering or above the window. [. . . ] Other glass-break simulators will not give accurate indication of range. Point the front of the simulator at the unit and press the red start button. (Refer to Figure 6. ) You should hear a short buzz from the simulator, and the green LED on the FG-1025 should begin flashing about once per second to indicate it is in Test Mode. NOTE: In Test Mode the LED disable switch is overridden. Use needle-nose pliers to break out the plastic tab on the back of the unit. (See Figure 4. ) The wall tamper arm will then extend through the hole. The wall tamper screw (not provided) should be a flat-head #8 (M 4) or #10 (M 5) screw. Install the wall tamper screw so that it will just make contact with the bottom of the tamper cavity when the unit is mounted. After installing the wall tamper screw, position the unit over it and mark the locations for the mounting screws. TESTING (Continued) IMPORTANT: Some environmental factors may reduce the sensor activation range. If you do not see the green LED flashing after pressing the red start button, move closer to the unit and try again. After testing, exit the Test Mode using the same procedure for activating the Test Mode. LED Indicators: The two LED's on the front cover are used to indicate the sensor's operational status. The following table summarizes the LED operation when the LED's are enabled. Condition Normal, no event Normal, event detected Normal, break detected Power-up self-test Trouble detected Test mode, no alarm Test mode, event detected Test mode, alarm Green LED OFF Flicker OFF ON, one second Flash ON/OFF Flash once per second Flicker Flash once per second Red LED OFF OFF ON ON, one second Flash OFF/ON OFF OFF ON Red Start Button Figure 6 If an FG-701 is not available, or if for any reason remote activation cannot be used, use a screwdriver to short the test pads at location S3 on the PCB (see Figure 1). Make sure to close the front cover of the FG-1025 before beginning test. The simulator will "click" on and start an eight second armed period. Position the FG-701 near the farthest point of the protected glass and point it directly at the FG-1025. Generate a flex signal by carefully striking the glass with a cushioned tool. (Refer to Figure 7. ) If both the flex and audio are received properly, the red alarm LED on the FG-1025 will light. IMPORTANT: If window coverings are present, close them fully and hold the FG-701 behind the window coverings for testing. NOTE: You can also use the simulator in the MANual mode to test audio alone. The blinking green LED on the unit will flicker when the simulator audio is received correctly. (See the FG-701 Operating Instructions for additional information. ) APPLICATIONS INFORMATION The FG-1025 is designed to detect framed glass broken by an impact sufficient to make a hole. To minimize the chance of false alarms: · · · Do not use outside. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. This warranty is void if the product held liable, whether directly or indirectly, for any loss or damage arising under this Limited is altered or improperly repaired or serviced by anyone other than IntelliSense factory service. For Warranty or otherwise, regardless of cause or origin, Seller's maximum liability shall not in any warranty service, contact the nearest IntelliSense service center. [. . . ]