User manual INTELLINET 550000

[. . . ] Network Video Server User's Guide Network Video Server Model 550000 User's Guide V1. 1 1 Network Video Server User's Guide FCC Compliance Statement The user manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. [. . . ] Before Event You may set the starting time to capture image before event is triggered. (Input limitation is from 0 to 21 seconds. ) After Event You may set the finishing time to capture image after event is triggered. (Input limitation is from 0 to 21 seconds. ) Image capture frame rate Set the frame rate from 1 to 15fps when the image is being captured. Image file name You may designate image file name to send Email or FPT after image is captured. "File name 000". JPG) Append to the image file name You may append some information to Image file Name Camera IP address A. Trigger condition flag In case of choosing "Activation of digital input port", "D" may be appended to image file name. Ex) "filename_D. JPG" In case of choosing "Periodically every. . . ", "P" is appended to image file name. Image sequence number If you select this option, you may classify the file that has same extend name. Consecutive numbers are from "000" to "999" Ex) If you designate file name as "camera" and select "Image sequence number", then the file names are: "camera001. JPG, camera002. JPG . . . . camera999. JPG" Image capture option limitation Configuration for image capture option affects memory capacity. If you configure this option to excess memory size, the Warning message " Not enough memory. . . " appears. (Before event time + After event time) x Image capture frame rate must be under 45. For example, in case you configure "Before event" as 3 seconds, "After event time" as 2 seconds and "image capture frame" as 3fps, the total image capture frame rate is (3 + 2) X 3 = 15 fps. 41 Network Video Server User's Guide 3. Trigger Output Here you define which action the camera is to perform when a trigger condition is met. 1. External devices signal output This is to supply voltage to output port when events are triggered. (This option is only activated when you select "Activation of digital output" option in previous "Trigger Condition" option. ) 2. Send alarm to ETSP client (currently not available, option not useable at this point) 3. Send captured image via E-mail This is to designate a person to receive captured image via Email. NETWORK VIDEO SERVER sends captured image to designated E-mail address through SMTP server. You may configure SMTP server and E-mail address where you want to receive. Send captured image to FTP server This is to send captured image from NETWORK VIDEO SERVER when an event is triggered. Enter ftp server IP address, User ID and Password and select directory to save image. The FTP Rename Option should be used if the camera is set to replace an existing image on a server every xx seconds. [. . . ] A set of rules (or a program) that allows a Web Server to communications with other programs. DSL ­Digital Subscriber Loop, A family of digital telecommunications protocols designed to allow high speed data communication over the existing copper telephone lines between end-users and telephone companies. DHCP - A protocol that provides a means to dynamically allocate IP addresses to computers on a local area network. The system administrator assigns a range of IP addresses to DHCP and each client computer on the LAN has its TCP/IP software configured to request an IP address from the DHCP server. [. . . ]