User manual INTELLINET 500517

[. . . ] 802. 11g Wireless LAN PCI Card User Manual Version: 1. 0 (March, 2004) COPYRIGHT Copyright ©2004/2005 by this company. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. [. . . ] TKIP ­ TKIP (Temporal Key Integrity Protocol) changes the temporal key every 10, 000 packets (a packet is a kind of message transmitted over a network. ) This insures much greater security than the standard WEP security. AES ­ AES has been developed to ensure the highest degree of security and authenticity for digital information and it is the most advanced solution defined by IEEE 802. 11i for the security in the wireless network. Note: All devices in the network should use the same encryption method to ensure the communication. WPA Pre-Shared Key The WPA-PSK key can be from eight to 64 characters and can be letters or numbers. This same key must be used on all of the wireless stations in the network. WEP Key (Key1 ~ Key4) The WEP keys are used to encrypt data transmitted in the wireless network. Select the default encryption key from Key 1 to Key 4 by selected the radio button. 64-bit ­ Input 10-digit Hex values (in the "A-F", "a-f" and "0-9" range) or 5-digit ASCII characters (including "a-z" and "0-9") as the encryption keys. 128-bit ­ Input 26-digit Hex values (in the "A-F", "a-f" and "0-9" range) or 13-digit ASCII characters (including "a-z" and "0-9") as the encryption keys. For example: "01234567890123456789abcdef" or "administrator". 3. 2. 2 Enable WPA in Windows XP Wi-Fi Protected Access (WPA) is a specification of standards-based, interoperable security enhancement that strongly increases the level of data protection (encryption) and access control 11 (authentication) for existing and future wireless LAN systems. The technical components of WPA include Temporal Key Integrity Protocol (TKIP) for dynamic key exchange, and 802. 1x for authentication. There are two types of WPA security: WPA-PSK (no server) and WPA (with server). WPA requires a Radius Server to complete the authentication among wireless stations and Access Points. A pre-shared key is a password that each wireless station uses the same key to access the network. To enable the WPA function in Windows XP, the following software systems are required: 1. Windows XP Service Pack 1 with Windows XP Support Patch for Wi-Fi Protected Access program in addition. Configure the card by Wireless built-in utility (Wireless Zero Configuration). Note: In that kind of system, there are two utility selections when you open the configuration utility of the card. You can select to use the XP's built-in utility with full WPA function. If "Use XP Wireless Zero Configuration" is selected, you can only configure the advance setting or check the link status and statistics from the "RaConfig" utility. 1. 2. From here, right click the icon to select "View Available Wireless Networks". Press "Advanced" button from "Wireless Network Connection". 12 3. Press "Configure" button to configure the WPA function for the current network. Note: Uncheck "Use Windows to Configure my wireless network settings", the "RaConfig" utility will be enabled again. Parameter Network Authentication Description Open ­No authentication is needed among the wireless network. [. . . ] Infrastructure is applicable to enterprise scale for wireless access to central database, or wireless application for mobile workers. What is BSS ID A specific Ad hoc LAN is called a Basic Service Set (BSS). What is WEP WEP is Wired Equivalent Privacy, a data privacy mechanism based on a 40 bit shared key algorithm, as described in the IEEE 802 . 11 standard. TKIP is a quick-fix method to quickly overcome the inherent weaknesses in WEP security, especially the reuse of encryption keys. [. . . ]