User manual INSIGNIA NS-BT400

[. . . ] Retain instructions--Retain the safety and operating instructions for future reference. Follow warnings--Follow all warnings on your speaker and in the operating instructions. Attachments--Do not use attachments not recommended by Insignia because they may cause hazards. Water and moisture--Do not use your speaker near water, for example, near a bath tub, in a wet basement, or near a swimming pool. [. . . ] If the pairing process cannot be completed within 90 seconds, the blue and red LED stops flashing and the Bluetooth function is automatically terminated. To disconnect the Bluetooth audio device from the speaker system, press and hold the button for three seconds to disconnect. A blue and red LED that flashes alternately for 90 seconds to indicate that the speaker is connecting and when the speaker is in pairing mode. The blue LED will flash constantly when the speaker system is connected to an audio source through Bluetooth wireless technology. 5 mm input cable from an external audio device directly into the AUX IN jack. Connect the small AC plug from the AC adapter into the AC 12V IN jack. To provide power to your speaker: · Plug the AC adapter into a wall outlet, then plug the AC cable from the adapter into the AC 12V IN jack on the back of the speaker. Note You need to pair the speaker with your Bluetooth devices before using the speaker. Pairing your speaker with Bluetooth devices Pairing is the process of associating your speaker with Bluetooth devices. Pairing establishes a permanent security link between the devices using Bluetooth wireless technology. You will be prompted to enter a PIN (personal identification number) to establish the initial pairing. After the pairing is successful, you will not have to re-enter the PIN. the device remembers the PIN and will automatically connect to the speaker. The following pairing instructions describe the pairing process between the speaker and a typical Bluetooth audio source. It is possible that the pairing process is different for your Bluetooth devices. If you have problems pairing, refer to the user's guide for your specific device. Notes When initiating pairing, keep the device to be paired within approximately 3 feet (1 meter) of the speaker and make sure that there are no other Bluetooth-enabled devices nearby. To pair your speaker with any Bluetooth A2DP device: 1 Turn on your speaker, then press and hold the PAIRING button for three seconds, until the Pairing LED flashes blue three times. The Pairing LED alternately flashes blue and red for 90 seconds, indicating that the speaker and the Bluetooth device are in pairing mode. Note If the pairing process cannot be completed within 90 seconds, the blue and red LED stops flashing and the Bluetooth function is terminated automatically. 3 Turn on the Bluetooth settings of your Bluetooth device, then perform a search for Bluetooth devices in range. When the blue LED flashes continuously, it indicates that the pairing process has been completed successfully. [. . . ] Make sure that you place the Product in its original packaging or packaging that provides the same amount of protection as the original packaging. If you purchased the Product from an online web site, mail your original receipt and the Product to the address listed on the web site. Make sure that you put the Product in its original packaging or packaging that provides the same amount of protection as the original packaging. To obtain in-home warranty service for a television with a screen 25 inches or larger, call 1-888-BESTBUY. [. . . ]