User manual INFOSEC XP OFFICE 1000 VA

[. . . ] Although it is a small UPS, it is equipped with Smart USB communication port to offer users more benefits. MAIN CHARACTERISTICS Microprocessor control guarantees high reliability Equipped with boost and buck AVR Built-in USB Communication Port Green Power Function for energy saving DC Start Function Auto restart during AC recovery Compact size, lightweight Provides modem / phone line surge protection 3. sAFETY INSTRUCTIONS ­ Security The UPS unit uses potentially hazardous voltages. [. . . ] This is done by leaving it connected to the mains power supply for 24 hours. Batteries kept in storage should be recharged every 3 months, failure to do so could result in battery damage. When calling the After-Sales Department, please have the following information ready, it will be required regardless of the problem: UPS model, serial number and date of purchase. accurate description of the problem providing the following details: type of equipment powered by the UPS , indicator led status , alarm status , installation and environmental conditions. You will find the technical information you require on your guarantee or on the identification plate on the back of the unit. Checking When you receive your equipment, open the packaging and check that your UPS has not been damaged. Charging the batteries This unit is shipped from the factory with its internal battery fully charged, however, some charge may be lost during shipping and the battery should be recharged prior to use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving it plugged-in, with no load, for at least 8 hours. Where to set up The UPS has been designed to operate in a protected environment, at temperatures between 0°C and 40°C and at a humidity level ranging between 0% and 90% (no condensation). Install the unit in an environment which is free from dust, chemical vapours and conductors. Moreover, in order to avoid any interference, keep the UPS at least 20cm away from the CPU (central processing unit). Connection Check on the identification plate at the back of the UPS that the power supply is compatible with network voltage and that the device is powerful enough to protect the given power load. Plug the UPS into a 2-pole, earthed outlet (use the original power cable of your computer or it is recommended to use a power cable 2P+E/CEE22/10A). Then, use the 3 IEC cables to connect one computer-related device to each of the power outlets supplied on the back of the UPS. You can also connect a device that does not require backup time, such as a printer, to the surge protected and filtered outlet. To start the UPS in the absence of a power supply and with a full battery, press the button. Power Saving Function XP range is equipped with a Power Saving Function. If no load connects to the UPS, it will automatically shut down after 5 minutes to save energy during a power failure. [. . . ] Batteries have a very high short circuit current: connection errors could cause electric arcs resulting in serious burns. TROUBLE SHOOTING Should the UPS fail to function correctly we recommend you perform the following tests before calling the Hot Line. ⷠDoes the power supply fall within specified unit values? [. . . ]