User manual IMG STAGE LINE TWIST-252

[. . . ] During transportation of the unit only seize the carrying handles (3). For cleaning the housing only use a dry, soft cloth, never use chemicals or water. No guarantee for the unit and no liability for resulting damage to property or resulting personal injuries will be accepted if the unit is used for other purposes than originally intended, if it is not correctly mounted or operated or not repaired in an expert way. If the unit is to be put out of operation definitively, take it to a local recycling plant for a disposal which is not harmful to the environment. [. . . ] The unit must have a minimum distance of 1 m to adjoining surfaces and the air vents at the housing must not be covered in any case. Pay in any case attention to a sufficient distance to easily flammable material or material sensitive to heat. If the unit is installed as a suspended load above persons, it must additionally be secured (e. Screw the supplied safety lug into the thread jack in the centre of the lower side of the unit and attach the safety rope to it. Fix the other end of the safety rope in such a way that the maximum falling distance of the unit is 20 cm. The following lamp may be used from the "img Stage Line" product range: Never touch the glass bulb of the lamp with your fingers!As soon as the unit is connected to the mains voltage, the POWER switch (7) lights up. If the unit is only shortly switched off or disconnected from the power supply only for a short time, the lamp does not immediately light up again. If no DMX control signal is present at this input, the yellow LED MASTER (12) lights up and the display (8) signalizes (Show 1) or (Show 2). For the music control switch off the function Blackout via the menu or with the remote control LC-3 (button STAND BY), otherwise the panning head remains in its initial position and the light beam is stopped down. A) Press the button MENU (9) four times so that the display shows (blackout mode). If the button ENTER is not actuated within 8 seconds, the unit switches back to the previous adjustment. E) To start the programme sequence, shortly switch the unit off and on again with the POWER switch (7). A) To switch between Show 1 and Show 2 press the button MENU (9) twice so that the display shows (show mode). then the selected operating mode reappears and the programme sequence starts. If the button ENTER is not actuated within 8 seconds, the unit switches back to the previous adjustment. 3) Adjust the control SENSITIVITY (16) for the microphone sensitivity so that the dynamic power of the music is reproduced in an optimum way by the movements of the light beam as well as by the change of the light patterns and colours. the highest sensitivity is set if the control is fully turned to the right. If the colour, the pattern, or the movement is changed by music control, the green LED SOUND (12) shortly lights up in each case. Note: If the volume of the music system changes, the microphone sensitivity must be adapted accordingly via the rotary control. 1 Interconnecting several TWIST-252 units Several units can be interconnected in order to control all further auxiliary units (slave units) to the same rhythm via the microphone of the main unit (master unit). 2) Connect the connection DMX OUT of the first auxiliary unit to the connection DMX IN of the second auxiliary unit, etc. [. . . ] Operating steps 1) Press the button MENU (9) so many times until the corresponding display is shown. 2) In case of the first seven menu items ( start address to tilting of panning head) confirm the selection with the button ENTER (11). Then make the adjustment with the button DOWN or UP (10) and memorize it with the button ENTER within 8 seconds. For the menu item of display presentation, the adjustment is immediately changed with the button ENTER and the selected function is activated for the last four menu items( fixed position of panning head to reset). [. . . ]