User manual IIYAMA PROLITE B2480HS

[. . . ] All trademarks used in this user manual are the property of their respective owners. ® ® As an ENERGY STAR Partner, iiyama has determined that this product meets the ENERGY STAR guidelines for energy efficiency. If you notice any abnormal phenomena such as smoke, strange sounds or fumes, unplug the monitor and contact your dealer or iiyama service center immediately. Removing the cabinet may expose you to the danger of fire or electric shock. [. . . ] If you are using a power supply higher than this rating, then a power cable with a rating of 10A/250V must be used. However, all guarantees and warranties are void for any problems or damage caused by a power cable not supplied by iiyama. <Removal> A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. A Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched. B Hold the monitor and push the Stand-Base until it clicks and is secure. Power Switch ( ) / Power Indicator Normal operation NOTE Blue: Orange: Power Management Select / Input select Button ( Scroll up / Audio Adjust Button ( Scroll down / i-Style Color Button ( Menu Button ( Speakers Keyhole for Security Lock NOTE You can fasten a security lock and cable to prevent the monitor from being removed without your permission. Connect the monitor to the audio equipment with the Audio Cable for computer when using the audio features. Connect the Power Cable to the monitor first and then to the power supply. NOTE The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. the cable supplied with the monitor is for a standard 15 pin D-Sub connector. When button operations are aborted during adjustment, On-Screen Display disappears button can be used to when the time set for the OSD Time Out has passed. Any changes are automatically saved in the memory when the On Screen Display disappears. Except for these adjustments, all other adjustments have only one setting which applies to all signal timings. * For best results, use the Auto Image Adjust in conjunction with the adjustment pattern. You can skip the Menu items and display an adjustment scale directly by using the following button operations. Button for about 2 seconds when the Menu is Too dull Too intense Too dark Too bright Off On Off Typical Contrast Ratio Increased Contrast Ratio Normal Brightness of back-light is reduced. Off / 1 / 2 / 3 / 4 / 5 It will improve the gray level response time of the LCD panel. *1 Adjust the Brightness when you are using the monitor in a dark room and feel the screen is too bright. *2 Brightness and ACR can not enable the same time when ECO Mode is on. *3 Contrast, Brightness, ACR and ECO Mode adjustments are disabled when i-Style Color is activated. Input source is fixed, not selected automatically when VGA, DVI, HDMI1 and HDMI2 which are selected. [. . . ] Another way to make the Clock adjustment is to correct the vertical wavy lines in the zebra pattern. In case the picture frame is bigger or smaller than the data display area after the Clock adjustment, repeat steps from C. G Adjust the Phase to correct horizontal wavy noise, flicker or blur in the zebra pattern. In case the strong flicker or blurs remain on a part of the screen, repeat steps F and G because the Clock may not be adjusted correctly. [. . . ]