User manual IHOME STUDIO

[. . . ] When unit is off, docking an already playing iPhone or iPod will turn it on. 4 USING LINE-IN LINE-IN JACK Connect one end of a standard stereo 3. 5mm audio cable (not included) into the line-in jack on the back of your iHome and the other into the headphone or output jack of your audio device. Do not play an line-in audio device and a docked iPhone or iPod at the same time or you will hear both sources. 5 VIDEO-OUT Your iHome is capable of outputting video stored on your iPod/iPhone to your television via the jacks on the rear. Depending on your model of iPod/iPhone, the supported video-out characteristics vary. See below. For component video, use the three jacks on rear For composite video, use only the center jack PR PB Y PR PB Y iPod classic, 3G iPod nano, 4G iPod nano, 2G iPod touch, iPhone 3GS: These iPod models can output progressive scan component video. [. . . ] Ventilation ­ The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. Heat ­ The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. Power Sources ­ The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Power-Cable Protection ­ Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. Objects and Liquid Entry ­ Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. Attachments ­ Do not use attachments not recommended by the product manufacturer. Lightning and Power Surge Protection ­ Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. Overloading ­ Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Damage Requiring Service ­ The unit should be serviced by qualified service personnel when: A. objects have fallen into or liquid has been spilled into the enclosure. the unit exhibits a marked change in performance or does not operate normally. Periods of Non use ­ If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion. Servicing ­ The user should not attempt to service the unit beyond those methods described in the user's operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel. Magnetic Interference: This product's speakers contain powerful magnets which could cause interference or damage to sensitive equipment such as hard drives, CRT televisions and monitors, as well as medical, scientific, and navigational devices. Keep this unit away from these products at all times. 9 A GUIDE TO PRODUCT SAFETY This device complies with Part 15 of the FCC Rules. [. . . ] (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except for a $60. 00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. [. . . ]