User manual IDK MULTIMEDIA CP-800 CARACTERISTIQUES TECHNIQUES

[. . . ] Touches Magnétoscope et Touches Télétexte Video Recorder keys and Teletext keys Before you can use your new remote, you will need to program it to operate the specific A/V home entertainment equipment you wish to control. Simply enter the proper device codes for your equipment and it is ready to use. [. . . ] NOTE : To leave the SETUP during the code entering, just press any of the [DEVICE] keys once. Otherwise, if no code is entered within 10 seconds, the red LED light will go out automatically. This auto search method checks all its preprogrammed codes to find the code that will operate your equipment automatically. Press & hold the [SET] key and [POWER] key at the same time for 4 seconds until the red LED light blinks. If the TV turn off, this indicates that the CP-800 is now set to your TV. To program other equipment, repeats the Steps 1-6 for your VCR, SAT, AUDIO and or your second TV or VCR. This manual search method checks all its preprogrammed codes to find the code that will operate your equipment. Press the [SET] key once again, the red LED light will flash continuously. HINT : During the Manual Search mode, you can use the [SET] key as forward/backward toggle switching to locate the correct code of your TV in a quick way. To program other equipment, repeat the Steps 1-8 for your VCR, SAT, AUDIO and or your second TV or VCR. NOTE 2 : To leave the MANUAL SEARCH during the code searching, just press any of the [DEVICE] key once. Otherwise, if no code is entered within 10 seconds, the red LED light will go out automatically. [. . . ] For example, press key for 1st digit of code, press key for 2 nd digit of code and press key for 3 rd digit of code. Press & hold the [SET] key, then press the desired digit code you want to display. [. . . ]