User manual IDEAL 61532

[. . . ] ND 5415-1 61-532 Instructions 7/19/05 11:56 AM Page 1 #61-532 Automatic Circuit Identifier with Analog Receiver The task of locating AC circuits is now made quick and easy. [. . . ] Always double check with a voltage tester/meter that the correct breaker or fuse was turned off before performing any work. LED Power Switch Features: · Automatically and quickly finds correct breaker · Transmitter works on 120VAC · Verifies presence of power Battery Compartment Locating A Circuit Breaker or Fuse: 1. Verify the proper AC voltage level at the wall outlet with an IDEAL voltage tester. Turn the receiver on, and allow it to complete its self-test away from power. Place the flat surface of the tapered end of the receiver directly onto the circuit breaker or fuse as shown. If the receiver is held at any other angle inaccurate readings may occur. Move the receiver down each side of the panel passing over each breaker or fuse, the receiver will beep continuously and the LED will turn off at the circuit powering the transmitter. Turn breaker off and check that the LED of the transmitter, in the outlet are off to confirm you have selected the correct breaker or fuse to turn off. Locating a Circuit Breaker or Fuse Controlling an Incandescent Light Fixture 1. [. . . ] SPECIFICATIONS: Operating Voltage: 100-140VAC Operating Frequency: 47-63Hz Maximum Load: 18A (4ms) at 120VAC, 200mW max, at 120VAC Duty Cycle: Max: 4mS every 16. 6mS (continuous), (. 24%) Weight (excluding battery): Transmitter approx 50gr. , Receiver approx. [. . . ]