User manual ICOM IC-F4TR

[. . . ] . 4-2 Audio output power · RECEIVER Sensitivity (12 dB SINAD) : 0. 3 µV Intermodulation rejection ratio : 75 dB typ. (12. 5 kHz) : 500 mW (at 5% distortion with an 8 load) AVOID the use of chemical agents such as benzene or alcohol when cleaning--use a water-dampened cloth only. SUPPLIED ACCESSORIES q w e r Battery pack (comes attached to the transceiver) Flexible antenna Belt clip 1922 A-REAR SHEET All stated specifications are subject to change without notice or obligation. For U. S. A. [. . . ] If the battery pack or case becomes wet, be sure to wipe it dry BEFORE attaching it to the transceiver. Also, current may flow into nearby metal objects so be careful when placing battery packs in handbags, etc. If your battery pack seems to have no capacity even after being charged, completely discharge it by leaving the power ON overnight. If the battery pack still does not retain a charge (or very little), a new battery pack must be purchased. q w e r MULT I-CHA RGER t y u i D Recycling information (U. S. A. only) The product that you have purchased contains a rechargeable battery. At the end of its life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Call 1-800-822-8837 for battery recycling options in your area or contact your dealer. BC-121 + AD-81 (6 pcs. ) AC adapter, BC-124 (purchased separately) BC-119 + AD-81 D BELT CLIP Attach the belt clip to the transceiver as illustrated below. Attach the belt-clip Release the belt-clip o q ANTENNA CONNECTOR Connects the supplied antenna. u CHANNEL UP/DOWN KEYS [Y]/[Z] Push either switch to change the operating channel. i DEALER PROGRAMMABLE KEYS [P0]/[P1]/[P2]/[P3]/[A]*/[B]*/[C]*/[D]*/[]*/[­] Can each be programmed for one of several functions by your Icom dealer or system operator. D Programmable key reference. [­] [P0] [P1] [P2] [P3] *10-keypad type only. []* [A]* [B]* [C]* [D]* 3-2 Battery case D ANTENNA The antenna screws onto the transceiver as illustrated as at right. When using the optional BP-194 attached to the transceiver, install 8 AA (R6) size Alkaline or Ni-Cd batteries as illustrated as at right. [. . . ] If the power-up tone still does not sound or a channel number does not appear, charge the battery or replace it. 3-3 Battery charging Prior to using the transceiver for the first time, the battery pack must be fully charged for optimum life and operation. CAUTION: To avoid damage to the transceiver, turn it OFF while charging. [. . . ]