User manual ICOM IC-F29SR

[. . . ] NOTE: Refer to the instruction sheet that comes with the transceiver for the default settings of these keys. W hen a scan is started with the Power ON Scan or Automatic scan function, push this key to pause it. Hold down to set the operating channel as the Prior- While holding down this key, the transceiver opens Any squelch, or releases any mute. W hen this function is ON and a signal is received, a beep does not sound and the status indicator does not light, even if you push any key. [. . . ] T o determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] repeatedly, listening for the loudest beep (level 5). TtRotate [VOL] to turn OFF the power to exit the beep level adjustment mode. Setting the ringer level You can adjust the ringer level between 1 and 5, or 1 (linked) and 5 (linked). When a linked option is selected, you can adjust the ringer level by rotating [VOL]. EeWhile holding down [Lower], rotate [VOL] to turn ON the power and enter the ringer level adjustment mode. RrPush [Upper] to increase, or push [Lower] to decrease the ringer level as shown to the right. Therefore, you Can determine the current level setting by the increasing loudness of the beep that sounds. T o determine if you have selected a linked level, set [VOL] to minimum, then push [Upper] up to 10 times, listening for the loudest beep (level 5). Repeatedly push [Upper] or [Lower] to select the desired linked level. TtRotate [VOL] to turn OFF the power to exit the ringer level adjustment mode. Setting the group code number dDCTCSS tone setting The transceiver is equipped with 50 CTCSS tones. CTCSS operation enables silent standby, since you will only receive calls from group members using the same CTCSS tone. WwSet [ROTARY SELECTOR] to any channel other Rotate [VOL] to turn ON the power. rrRotate [ROTARY SELECTOR] to select the desired Channel (1 to 16) that you want to assign the CTCSS tone to. YyPush [PTT] the necessary number of times to enter the ten's digit of the desired CTCSS tone number (grey column) as shown in the list below. IiPush [PTT] the necessary number of times to enter the one's digit of the desired CTCSS tone number (grey column) as shown in the list below. nOTE: · If you make a mistake, go back to step q and follow If you want to enter "0, " do not push [PTT] in step t To turn OFF the CTCSS tone, enter "00. wwWhile holding down [PTT] , [Upper] , and [Lower] , Rotate [VOL] to turn ON the power. EeRotate [ROTARY SELECTOR] to select channel 4, then hold down [Upper] until two beeps sound. RrPush [PTT] two times to enter "2" (the ten's digit) of the number 28. [. . . ] YyPush [PTT] six times to enter "6" (the one's digit) of the number 16. Higher levels make the microphone more sensitive to the user's voice. EeWhile holding down [Upper], rotate [VOL] to turn ON the power and enter the microphone gain adjustment mode. RrPush [Upper] or to increase, or push [Lower] to decrease the microphone gain. [. . . ]