User manual ICOM IC-4GXE

[. . . ] You can also set up selective calls to individuals or control a repeater. IC-F70T IC-F80S Multiple 2-Tone, Multiple 5-Tone Up to 10 2-Tone and 8 5-Tone codes can be decoded on a single memory channel. This is perfect for professionals who require multiple district paging on one channel. When a matched tone is received, the following items are programmable for each code. [. . . ] When a matched tone is received, the following items are programmable for each code. · Bell icon · Answer back · Stun · Beep sound · Auto transmit · Scan P25 digital/analog FM with 10-keypad P25 digital/analog FM with 10-keypad P25 digital/analog FM without 10-keypad P25 digital/analog FM without 10-keypad Interoperability The IC-F70D, F80D series is APCO Project 25 (P25) compliant. It ensures interoperability with other manufacturer's P25 digital radios in conventional mode. Upgrade to digital option* The IC-F70D, F80D series is available in two digital versions. Version two is an analog only radio that is future upgradeable to P25 digital compatibility­ grow into digital with Icom. (* Upgrade software available later. ) Mixed mode operation The IC-F70D, F80D series is compatible with both analog FM mode and P25 digital mode. The mixed mode scan allows you to detect and receive both analog FM and P25 digital modes and to transmit either mode depending on programming. Other features · NAC (Network Access Code) operation provides quiet stand-by in a large group and is used to open a closed digital repeater. · Selective call/individual call using Unit ID and talkgroup ID · 100 Unit ID, 250 talkgroup ID memories Li-Ion battery pack The large capacity 1600mAh Lithium-Ion (Li-Ion) battery pack, BP-235 provides a practical 8 hours* of operating time. Li-Ion batteries allow flexible charging and have almost no memory effect. * Typical operation Tx:Rx: Stand-by=5:5:90 Wide range coverage and large channel capacity The IC-F70/F80 series covers a wide frequency range in one version. For use with MB-94. ANTENNAS · FA-SC25V : 136­150MHz · FA-SC55V : 146­174MHz · FA-SC25U : 400­430MHz · FA-SC57U : 430­470MHz · FA-SC72U : 470­520MHz UT-109 : Provides 32 non-rolling type scrambling codes. Optional internal unit should be installed at an authorized Icom service center only. ANTENNA CONNECTOR ADAPTER AD-98FSC : Allows you to connect a BNC-type antenna. (For maintenance use only) VHF AND UHF TRANSCEIVERS SPECIFICATIONS GENERAL RECEIVER · Frequency range : IC-F70T/S, F70DT/DS 136­174MHz IC-F80T/S, F80DT/DS 400­470MHz 450­520MHz · Number of channels · Channel spacing · PLL channel step · Antenna impedance : 256 channels/32 zones : 12. 5kHz/25kHz, 15kHz/30kHz : 2. 5kHz, 3. 125kHz (VHF) 5kHz, 6. 25kHz (UHF) : 50 · Intermediate frequency · Sensitivity VHF UHF : 1st : 46. 35MHz 2nd 450kHz 0. 25µV typ. (5% BER APCO) · Squelch sensitivity (at threshold) : VHF 0. 25µV typ. (APCO) · Spurious response VHF UHF · Intermodulation · Hum and noise ratio · Audio output power : 80dB typ. (Wide/narrow) : 500mW typ. (at 5% distortion with an 8 load) · Usable temperature range : ­30°C to +60°C; ­22°F to +140°F · Power supply requirement : 7. 2V DC · Output power and current drain (at 7. 2V DC; approx. ): Output power High Transmit Low (1W) AF max. Receive stand-by IC-F70, F70D IC-F80, F80D 5W 4W 2. 2A 2. 4A 1. 5A 1. 5A 450mA 450mA 150mA 150mA · Dimensions (with battery pack): 58. 6 (W) ×152 (H) ×38 (D) mm; (projections are not included) 25/16 (W) ×5 31/32 (H)×11/2 (D) in · Weight (approx. ) : 400g; 14. 1oz (with BP-235) 430g; 15. 6oz (with BP-236) TRANSMITTER · External speaker connector: 9-pin multi connector/8 · Max. frequency deviation : ±5kHz (Wide) ±2. 5kHz (Narrow) · Frequency error · Spurious emissions · FM Hum and Noise VHF UHF · Modulation limiting : ±2. 0ppm : 70dB typ. VHF antenna Supplied accessories: (May differ according to version) · Adjacent channel power : 70dB (Wide), 60dB (Narrow) : 45/40dB typ. [. . . ] (Wide/narrow) : 500mW typ. (at 5% distortion with an 8 load) · Usable temperature range : ­30°C to +60°C; ­22°F to +140°F · Power supply requirement : 7. 2V DC · Output power and current drain (at 7. 2V DC; approx. ): Output power High Transmit Low (1W) AF max. Receive stand-by IC-F70, F70D IC-F80, F80D 5W 4W 2. 2A 2. 4A 1. 5A 1. 5A 450mA 450mA 150mA 150mA · Dimensions (with battery pack): 58. 6 (W) ×152 (H) ×38 (D) mm; (projections are not included) 25/16 (W) ×5 31/32 (H)×11/2 (D) in · Weight (approx. ) : 400g; 14. 1oz (with BP-235) 430g; 15. 6oz (with BP-236) TRANSMITTER · External speaker connector: 9-pin multi connector/8 · Max. frequency deviation : ±5kHz (Wide) ±2. 5kHz (Narrow) · Frequency error · Spurious emissions · FM Hum and Noise VHF UHF · Modulation limiting : ±2. 0ppm : 70dB typ. VHF antenna Supplied accessories: (May differ according to version) · Adjacent channel power : 70dB (Wide), 60dB (Narrow) : 45/40dB typ. [. . . ]