User manual ICOM BC-30 SCHEMATIC

[. . . ] Charging indicator BC-30 PRECAUTION · RUSE INDOORS ONLY!· NEVER use the charger when it is covered by objects which impede heat dispersal. [. . . ] · AVOID charging in conditions of extreme cold (under 10°C; +50°F) or extreme heat (over +40°C; +104°F). · Turn the transceiver power OFF when charging with the battery pack attached to the transceiver to obtain a full charge. · Keep the charger away from TV sets or radios to prevent interference. Make sure battery and charger contacts are always clean, otherwise batteries may not fully charge. Avoid overcharging-- batteries must be removed from the charger to stop charging. Batteries should not be charged for more than 15 hours after the charging indicator turns green. At the end of its life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Call 1-800-822-8837 for battery recycling options in your area or contact your dealer. Icom, Icom Inc. and , logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries. Red The inserted battery pack or the charger has a (Blinks) problem. *When the charging indicator does not light even after a battery pack is inserted properly, the battery pack may have a problem. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan A-6396D-1EX Printed in Japan © 2004 Icom Inc. AD-99 SPACER COMBINATIONS · For IC-F30G Series The adapter (Spacer A) only is required. Spacer A · For IC-F3G Series Check orientation and Spacer A Attach the spacer (Spacer B/C) to the adapter (Spacer A) with the orientation as illustrated in the diagram at left. · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " " pointing up. Spacer B/C · For IC-F11 Series Check orientation Spacer A and Attach the spacer (Spacer B/C) to the adapter (Spacer A) with the orientation as illustrated in the diagram at left. · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " " pointing up. Spacer B/C When removing the spacer (Spacer B/C) Remove the spacer (Spacer B/C) from the adapter. Push the notch carefully. Push the notch carefully with your finger to remove the spacer (Spacer B/C) from the adapter (Spacer A). [. . . ] Push the notch carefully. Push the notch carefully with your finger to remove the spacer (Spacer B/C) from the adapter (Spacer A). DO NOT push or force the notch using a screw driver, etc. , to remove it. [. . . ]