User manual ICOM BC-146

[. . . ] 18. 5 hrs; depending on battery pack) BC-146 BATTERY CHARGER Please read these instructions thoroughly before operating the BC-146. CAUTION · RUSE INDOORS ONLY!· NEVER use the charger when it is covered by objects which impede heat dispersal. [. . . ] Use the batteries until they become almost completely exhausted under normal conditions. If your batteries seem to have no capacity even after being fully charged, completely discharge them, then fully charge them again. If they still do not retain a charge (or very little), new batteries must be purchased. Recycling information (U. S. A. only) The battery (BP-209 or BP-222) that you have purchased is recyclable. At the end of its life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Call 1800-822-8837 for battery recycling options in your area or contact your dealer. BATTERY PACK CHARGING · Charging with transceiver Turn power OFF CP-1, CP-17L or OPC-515L (Option) AC adapter (Option; BC-147A/E BC-122V) Charging indicator Check orientation and the spacer combination. See the back page for details. · Charging battery pack only BP-209, BP-210 or BP-222 only CP-1, CP-17L or OPC-515L (Option) AC adapter (Option; BC-147A/E BC-122V) Check orientation. charging period BP-209 : 12 hours BP-210 : 18. 5 hours BP-222 : 6. 5 hours NOTE: The charging indicator will not go out even after a battery pack is fully charged. Count on us! 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003 Japan A-6026D-1EX Printed in Japan © 2001 Icom Inc. SPACER COMBINATIONS · Charging with the IC-F11 Series Check orientation Spacer A and · Charging with the IC-F3G Series Check orientation and Spacer A Spacer B/C Spacer B/C Attach the spacer (Spacer B/C) to the adapter (Spacer A) with the orientation as illustrated in the diagram above. · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " " pointing up. Attach the spacer (Spacer B/C) to the adapter (Spacer A) with the orientation as illustrated in the diagram above. · Attach the spacer (Spacer B/C) to the adapter with the orientation of the stamp " " pointing up. · Charging with the IC-F30G Series Spacer A The adapter (Spacer A) only is required. When removing the spacer (Spacer B/C) Remove the spacer (Spacer B/C) from the adapter. [. . . ] Both cases may break the notch and it may not be able to be reattached. , Icom Inc. are registered trademarks of Icom Incorporated (Japan) in the United States and/or other countries. [. . . ]