User manual ICOM BC-119N

[. . . ] INSTRUCTIONS DESKTOP CHARGER BC-1 19 N Thank you for purchasing the BC-119N DESKTOP CHARGER. Please read these instructions thoroughly before operating the BC-119N. ATTACHING A DESKTOP CHARGER ADAPTER There are 2 desktop charger adapter types for the BC-119N. For some versions, the AD-75 or AD-88 is already installed in the BC-119N. [. . . ] At the end of its life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Call 1-800-822-8837 for battery recycling options in your area or contact your dealer. Make sure battery and charger contacts are always clean, otherwise batteries may not fully charge. These instructions contain important safety and operating details for the BC-119N. An appropriate desktop charger adapter must be purchased separately to charge your Icom battery packs. Avoid overcharging-- batteries must be removed from the charger to stop charging. Batteries should not be charged for more than 15 hours after the LED indicator turns green. Use the batteries until they become almost completely exhausted under normal conditions. If your batteries seem to have no capacity even after being fully charged, completely discharge them, then fully charge them again. If they still do not retain a charge (or very little), new batteries must be purchased. Some versions of the BC-119N which display the "CE" symbol on the serial number comply with the essential requirements of the 89/336/EEC directive for Electromagnetic Compatibility. This compliance is based upon the harmonised CENELEC generic standard EN50 081-1: 1992 and EN50 082-1: 1991. Not used See NOTE below · Installing the non-PCB type adapter See NOTE below NOTE: Some of the PCB type desktop charger adapters (incl. The connection is required only for the installing adapter that is compatible with charging a Li-Ion battery pack. About the 3-pin connector: When you replace the desktop charger adapter from the Li-Ion compatible type to non-compatible type, fix the 3-pin connector to the bottom of the charger with adhesive tape, etc. , to prevent catching or touching the 3-pin connector's terminals with the adapter's leads, etc. Icom, Icom Inc. and are registered trademarks of Icom Incorporated (Japan) in the United States, United Kingdom, Germany, France, Spain, Russia and/or other countries. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003 Japan A-6099D-1EX-q Printed in Japan © 2001 Icom Inc. CHARGING OPERATION · Charging example-- AD-102 for IC-M1V/M1EURO V CAUTION The transceiver power MUST be turned OFF during charging otherwise; · The battery will not be charged correctly. OPC-515L or CP-17L DESKTOP CHARGER ADAPTERS D PCB type adapters Transceiver IC-F10/F20, IC-M10A/E, IC-2GX series, IC-V68/U68 Charger Adapter Battery pack BP-157/A, BP-160/R, BP-174 CM-140/141/142* CM-138/139/165 BP-185/186 D Non-PCB type adapters (AD-75 or AD-88 is required) Transceiver IC-W21/X21, IC-2GX series IC-A3/A22 IC-Z1A/E, IC-W31/W32 IC-T22/T42, IC-T7A/E/H IC-T8, IC-T81, IC-A5/A23 Charger Adapter Battery pack AD-66 AD-28 BP-131/132/157/A +AD-75 BP-160/174 AD-50 CM-166 +AD-75 AD-51 BP-171/172/173, +AD-75 BP-180 AD-56 BP-171/172/173, +AD-75 BP-180 AD-87 BP-198*/199*/200*/L* +AD-88* Use the spacer, if supplied with the charger adapter, for charging the battery pack with/without transceiver. IC-F30/F40, IC-F35/F45 IC-M15, IC-GM1500 IC-M1, IC-M1EURO IC-F3/F4/S, IC-T2H/A/E, IC-F4SR/TR IC-A4, IC-40S AD-67* AD-68 AD-69 AD-81 BP-195/196/R AC adapter (Not supplied with some versions. ) IC-4008A/E/M, IC-4008MKII, IC-446S, IC-40Jr AD-89 BP-202 *AD-67, AD-88, AD-94 and AD-101 have a temperature detection circuit for the Ni-MH battery. [. . . ] Therefore, charging the battery in intervals, and not for extended periods is recommended. SPECIFICATIONS Dimensions (proj. not incl. ) Weight : 115(W)×103(D)×60(H) mm 41/2(W)×41/16(D)×21/4(H) in. : 200 g; 7. 1 oz Charging current Charging temperature range: 10°C to 40°C; +50°F to +104°F Power supply requirement: 12 to 20 V DC or the specified Icom AC adapter (BC-145) : 420 mA±10% (rapid charging) 540 mA±10% (rapid charging) 670 mA±10% (rapid charging) 840 mA±10% (rapid charging) 30 mA±10 mA (trickle charging) 8 kV 4 kV Electrostatic durability : Air discharge Contact discharge All stated specifications are subject to change without notice or obligation. [. . . ]