User manual ICEBERG FOOTSICLE

[. . . ] Should you notice an abnormality in the unit, disconnect the main plug from the AC outlet immediately. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. Do not expose batteries or apparatus with battery-installed to excessive heat such as sunshine, fire or the like. The unit is not disconnected from the mains as long as it is connected to the AC outlet, even if the unit itself has been turned off. [. . . ] , You may not be able to move the playback position, depending on the content or the renderer (network controlled player). The same device has been registered again after you have deleted it. , Devices which have the DLNA renderer function will be registered with this unit automatically. Set the DLNA renderer function of the device to OFF when you do not want to display the device on the device list of this unit. , You cannot move the playback position if the cursor shown on the progress bar has not appeared. , You cannot move the playback position, even if there is a cursor shown on the progress bar, if the content currently being played back does not support the seek function. You cannot begin the selected Activity once the power-off dialogue is displayed, even if the server and renderer (network controlled player) are set to ON. , Make sure that the server and renderer (network controlled player) have not set access limitations. The total playback time of all content items is displayed as "--. " , "--" is displayed when the total playback time of all content items exceeds 999 minutes and 59 seconds. PARTY The PARTY currently being held is not displayed on the HOME screen. , Make sure the PARTY host has permitted access from this unit. You cannot select the playback range or playback mode. , Only the playback range or playback modes supported by the currently active renderer (network controlled player) are displayed. You cannot return to the content list even if you tap . , The server list appears when you tap , depending on the content currently being played back. , Make sure the unit has registered the PARTY host in advance. You cannot find devices having the PARTY STREAMING function. , Check the following possible causes. · This unit is not registered with any devices having the PARTY STREAMING function. · Devices having the PARTY STREAMING function are not turned on. You cannot find a new renderer (network controlled player). Refresh" on the , Make sure of the following. · Does the renderer (network controlled player) have access limitations even though you have not registered 30 devices yet?· Is the renderer (network controlled player) connected to your network correctly?Should any solid object or liquid get into the unit, unplug the unit, and have it checked by qualified personnel before operating it again. The AC power adaptor can be changed only by a qualified service facility. On placement · Do not place the unit in an inclined position or in locations that are extremely hot, cold, dusty, dirty, humid or lacking adequate ventilation, or subject to vibration, direct sunlight or a bright light. Be careful when placing the unit or speakers on surfaces that have been specially treated (for example, with wax, oil, polish) as staining or discoloration of the surface may result. On disposing of the remote control Before disposing of the remote control, the built-in battery should be removed for environmental protection. · Notes · · Do not remove the screws at the bottom of the remote control except when disposing of the remote control. Before removing the built-in battery, make sure it has completely drained. · About the AC power adaptor · Use the AC power adaptor supplied with this unit. Do not use any other AC power adaptor since it may cause this unit to malfunction. · Use the following procedure to remove the built-in battery. 1 · Remove the two screws on the bottom of the unit. Polarity of the plug · Connect the AC power adaptor or the power cord to an easily accessible AC outlet. Should you notice an abnormality in the AC power adaptor or the power cord, disconnect it from the AC outlet immediately. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. If you are not going to use this unit for a long time, be sure to disconnect the power supply. To remove the AC power cord from the wall outlet, grasp the adaptor plug itself; never pull the cord. · 2 · Open the rear cover using a flat object, such as a flathead screwdriver, then remove it. Rear cover · · · 76GB 3 Remove the two screws from the bottom cover. About this unit · If you have connected to an outside network, such as the Internet, and have allowed access from other devices, unauthorized access by malicious outsiders can occur depending on your network configuration. To avoid this problem, before using this unit, you need to: ­ Use a router and configure it correctly. It is prohibited to send or leave copyrighted products to/on an outof-home network which can be accessed from many people without the author's permission by the Copyright Act. [. . . ] Redistributions in binary form must reproduce all prior and current copyright notices, this list of conditions, and the following disclaimer in the documentation and/ or other materials provided with the distribution. The name of any author may not be used to endorse or promote products derived from this software without their specific prior written permission. ALTERNATIVELY, this product may be distributed under the terms of the GNU General Public License, in which case the provisions of the GNU GPL are required INSTEAD OF the above restrictions. (This clause is necessary due to a potential conflict between the GNU GPL and the restrictions contained in a BSD-style copyright. ) THIS SOFTWARE IS PROVIDED "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. [. . . ]