User manual HUSQVARNA WS 482 HF

[. . . ] Please read the operator's manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Approved protective helmet Approved hearing protection Protective goggles or a visor Breathing mask Protective goggles or a visor must be worn. [. . . ] People that need to be in close proximity of the machine must wear hearing protection as the sound level when cutting exceeds 85 dB(A). Make sure that no people or animals come closer than 4 m (15 ft) when the machine is running. Do not use the machine in bad weather, such as dense fog, rain, strong wind, intense cold, etc. Working in bad weather is tiring and can lead to dangerous conditions, e. Ensure that the working area is sufficiently illuminated to create a safe working environment. You are handling heavy parts, which implies the risk of pinch injuries or other injuries. Never use a blade for any other materials than that it was intended for. Operating saw blades at rotational speeds greater than those recommended by the manufacturer can cause blade damage and possibly subsequent injury. If the upper horizontal cut is made before the lower horizontal cut, the work piece will fall on the blade and jam it. When making the last cut, the saw should be mounted on an adjacent fixed wall. As the rail is symmetrical, the saw unit can be turned to make a new cut on the other side of the rail. In this way a cut piece is obtained that is in an easily handled size, making it easier to remove from the workplace. Since the blade rotation direction can be selected, the water spray from the blade can also be selected regardless of how the saw is turned on the rail. The cut should not be made at maximum speed, but with care in order to obtain a straight cut and with that a basis for the next cut. the cutting arm allows blades up to 1 000 mm (40") to be used as the start blade. The depth of these is determined from instance to instance and depends on factors such as hardness of the concrete, existence of reinforcing bar, etc. When cutting in hard concrete, a lower speed or a more shallow cut is required compared to cutting in soft concrete. This enables a high travel feed speed which results in a more effective and straight cut. If you change blades to cut deeper in the same cut, make sure the segment width of the blade matches the width of the groove. The heavy weight of cut material can cause extensive damage if it is not moved under controlled conditions. 2 m + saw carriage One track 2 m + saw carriage Four wall mountings One track holder One connector One blade guard 800 or one blade guard 1000 One blade guard guide One tool kit One bottle of Husqvarna oil 150 Transport cases for the different units. The saw carriage is mounted on both the long and short rails at the factory to make cutting as easy as possible. [. . . ] Adjust the guide wheels with the M10 nut (3) located on the rear side of the guide wheel until the play disappears. Enclose the area to be cut so that unauthorised persons can not be injured or disturb the operator. replace the blade or the blade guard if it is exposed to impact or is cracked. Check that all cables and the water supply are correctly connected to the machine before starting it. [. . . ]