User manual HUSQVARNA TS 66 R

[. . . ] The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occurring during delivery, or caused by the design or use of the machine. We are very concerned about the quality of our products and we reserve the right to make any technical modifications to improve them, without warning. [. . . ] Please read the instructions for use prior to operating the machine for the first time. Always keep it perfectly clean · check the supply cable and the extension lead periodically · Always keep alert when working · Check that the parts are properly fixed (no abnormal vibration) and that it is correctly assembled. The working area must be completely cleared, well lit and all safety hazards removed (no water or dangerous objects in the vicinity) The operator must wear protective clothing appropriate to the work he is doing. We recommend that this includes both eye and ear protection The use of ear protection is mandatory. Any persons not involved in the work should leave the working area Use only blades marked with a maximum operating speed greater than blade shaft speed Release the two knobs (C) - [SEE FIG. Take care about the direction of rotation which is shown by an arrow on one of the faces. Make sure the contact faces of flanges, of blade and the axle are clean. 3] ­ Lift up the back of the machine and slide the two rear legs into place. TRANSPORT ­ Lock the cutting head to the rear of the machine by means of the clip (A) - [SEE FIG. ­ Remove the legs in the reverse order to the assembly (first the front, then the back). Store them under the machine, remembering to fix them by tightening knob H [SEE FIG. For these different operations always disconnect the machine - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuit-breaker. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. Always keep blade guard in place For wet cutting: · Fill the tray with clean water (maximum level = base of the plate). [. . . ] The instructions for use and spare parts found in this document are for information only and are not binding. As part of our product quality improvement policy, we reserve the right to make any and all technical modifications without prior notice. Anslutning till nätet med en kabel typ H07 RNF med tvärsnittsareax: - 3 x 2, 5 mm2 upp till 50 m för 230 V - 3 x 4 mm2 upp till 40 m för 115xV Vi finns alltid till hands för dig för att reparera din maskin inom kortast möjliga tid och till våra bästa priser (adressen finns på baksidan). [. . . ]